ASRock E35LM1 [17/47] Asrock smart remote installation guide

USB 2.0 header (9-pin, black)

CIR header (4-pin, gray)

2.5 ASRock Smart Remote Installation Guide

ASRock Smart Remote is only used for ASRock motherboard with CIR header.

Please refer to below procedures for the quick installation and usage of ASRock

Smart Remote.

Step1. Find the CIR header located next

to the USB 2.0 header on ASRock

motherboard.

Step2. Connect the front USB cable to the

USB 2.0 header (as below, pin 1-5)

and the CIR header. Please make

sure the wire assignments and the

pin assignments are matched

correctly.

Step3. Install

Multi-Angle CIR Receiver to the front USB port.

Step4. Boot up your system. Press <F2> or <Del> to enter BIOS Setup Utility.

Make sure the option "CIR Controller" is setting at [Enabled].

(Advanced -> Super IO Conﬁ guration -> CIR Controller -> [Enabled])

If you cannot ﬁ nd this option, please shut down your system and install

Multi-Angle CIR Receiver to the other front USB port then try again.

Step5. Enter Windows. Execute ASRock support CD and install CIR Driver. (It is

listed at the bottom of driver list.)

USB_PWR

P-

P+

GND

ATX+5VSB

IRRX

IRTX

GND

DUMMY