Fluke micromapper [10/14] Micromapper tests

Превью страниц Страница 10 / 14

MicroMapper

User’s Manual

MICROMAPPER Tests

1. Slide the switch on the right side to the Cable

position to turn M

ICROMAPPER on.

2. Connect one end of the cable to be tested to the

ICROMAPPER’s RJ45 jack.

3. Connect the other end of the cable to the

ICROMAPPEr Remote’s RJ45 jack.

4. Press (TEST) to view the results.

5. The horizontal LEDs indicate the cable’s integrity

status.

• Green: Pair or Shield is good

• Green flashing: Pair or Shield is faulty

• No light: Pair is open or cable is not shielded

The vertical LEDs indicate the wiring faults and a

low battery status. Wiring faults are: SHORT,

REVERSED, MISWIRE, SPLIT PAIRS.

6. To find out a fault on a specific pair, use

ICROMAPPER’s diagnostic feature.

7. Press and hold

(TEST) for more than 2 seconds.

ICROMAPPER will scan each pair and the shield

pausing and flashing each green LED separately. If

a faulty pair is detected, the corresponding fault

status will blink in red.

Note

Push the Remote Terminator onto the

MicroMapper until it snaps into position. This

configuration allows you to conveniently test

patch cables.