Fluke micromapper [9/14] S toner operation

Превью страниц Страница 9 / 14

MicroMapper™

Battery

MICROMAPPER requires four 1.5 AAA batteries. IEC :

LR03. Others : AAA, E92, 4003; JIS : AM 4 ; ANSI : 24A;

1.5 Volt (nominal).

atx03s.bmp

The Battery LED will light up when MICROMAPPER

detects a low battery condition. Using MICROMAPPER

with a low battery may affect the test accuracy. If

ICROMAPPER is stored for more than a month, the

battery should be removed.

MICROMAPPER’s Toner Operation

1. Slide the switch on the right side of MICROMAPPER

to the Toner position.

2. Connect the cable to the M

ICROMAPPER’s RJ45 jack.

(To send a tone into a patch panel, connect one

end of the included patch cord to the

ICROMAPPER’s RJ45 jack and the other end to a

jack on the panel.)

3. To generate tone 1, press and quickly release the

(TEST) button.

4. To generate tone 2, press and hold the

(TEST)

button for two seconds.

5. Use the M

ICROPROBE to trace the connected cable.

The signal reception is strongest near the cable

under test.

6. Slide the switch on the right side to the Off

position to discontinue the tone. (Always power

the unit off to prevent battery drain.)