Robomow City 100 [15/44] Warning
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Robomow City 100 [15/44] Warning

Robomow City 100 [15/44] Warning
15
1.3.2 Laying Out the Perimeter Wire
Start setting the perimeter wire by placing pegs every few meters and at the lawn corners
according to your plan; do not forget obstacles that need to be demarcated while laying the
wire.
After removing enough wire within a given section, use the RoboRuler provided to set the
correct distance from the lawn edge. The RoboRuler is used to help position the perimeter wire
along walls, fences, sidewalk, driveways, flowerbeds and other perimeter zones.
There are two basic measurements that are used on the RoboRuler (Figure 1.12).
The shorter distance is used along perimeter edges where the area outside the immediate
perimeter is free of obstacles and is the same relative height as the perimeter edge or lower
(sidewalk on the same level or flowerbeds).
The longer distance is used along perimeter edges where the area outside the immediate
perimeter has obstacles or differences in the height along the perimeter edge (walls and
fences).
Important
If the lawn's edge borders with a pond, swimming pool or watercourse or where the grass
level is higher than 70cm (2ft) from the edge around it, then it is required to keep a distance of
at least 1.2m (4ft) between the wire and the water (or chasm) otherwise supplement a fence or
the same along the lawn's edge, so Robomow can detect it. The height must then be at least
15cm (6 inch). This will prevent Robomow, under any circumstances, from crossing the wire
outside the working area
1.3.3 Fastening The Wire To The Ground
It is not necessary to bury the perimeter wire, though you may do so if you wish, up to 10 cm
(4 inches) deep.
Small pegs or stakes are supplied with the Robomow and they are used to fasten and
hold the perimeter wire to the ground, below grass level.
Initially place a minimum number of pegs to fasten the wire down. Remember that you will want
to test the wire set up before you fill in additional pegs and you may find some areas where you
will need to move the wire position slightly.
Upon hammering the peg to its final depth in the ground, pull the wire tight. It is a lot easier to
insert pegs into wet soil. If the soil is dry, water the yard before perimeter wire set up.
WARNING!
Damage to the eye is possible. Use proper eye protection and wear
appropriate work gloves when hammering the pegs. Hard or dry ground
may cause pegs to break when driving them in. In extreme cases,
watering the lawn where the pegs will be driven can be beneficial.
Short distance of RoboRuler
– where the area outside
the immediate perimeter is
free of obstacles and is the
same relative height as the
perimeter edge or lower
Long distance of
RoboRuler – where
the area outside the
immediate perimeter
has obstacles or
differences in the
height along the
p
erimeter ed
g
e
Figure 1.12 – using the RoboRuler

Содержание

Похожие устройства

Скачать