CONEL SPECTRE v3 ERT [43/136] Pppoe bridge mode conﬁguration

Превью страниц Страница 43 / 136

4. CONFIGURATION

The following parameters speciﬁes the length of time that the router waits before attempting

to change back to the default SIM card or APN.

Item Description

Initial timeout Speciﬁes the length of time that the router waits before the ﬁrst

attempt to change back to the primary SIM card or APN, the range

of this parameter is from 1 to 10000 minutes.

Subsequent Timeout Speciﬁes the length of time that the router waits after an unsuc-

cessful attempt to change to the default SIM card, the range is

from 1 to 10000 min.

Additive constants Speciﬁes the length of time that the router waits for any further

attempts to change back to the primary SIM card or APN. The

length time is the sum of the time speciﬁed in the "Subsequent

Timeout" parameter and the time speciﬁed in this parameter, the

range is from 1 to 10000 minutes.

Table 25: Timeout Conﬁguration

Example:

If you mar k the Switch to default SIM card after timeout check box, and you enter the following

values:

• Initial Timeout – 60 min,

• Subsequent Timeout – 30 min,

• Additional Timeout – 20 min.

The ﬁrst attempt to change to the primary SIM card or APN is carried out after 60 minutes.

When the ﬁrst attempt fails, a second attempt is made after 30 minutes. A third attempt is

made after 50 minutes (30+20). A fourth attempt is made after 70 minutes (30+20+20).

4.3.6 PPPoE Bridge Mode Conﬁgur ation

If you mark the Enable PPPoE bridge mode check box, the router activates the PPPoE

bridge protocol. PPPoE (point-to-point over ethernet) is a network protocol for encapsulating

Point-to-Point Protocol (PPP) frames inside Ethernet frames. The bridge mode allows you to

create a PPPoE connection from a device behind the router. For example, a PC connected to

the ETH port of the router. You assign the IP address of the SIM card to the PC.

The changes in settings will apply after clicking the Apply button.