Graco IM5 239824 Инструкция по эксплуатации онлайн [10/14] 167831

Service

10 308687J

4. Remove all gasket material from the metering unit

(4).

5. Assemble adhesive side of new gasket (2) to meter-

ing unit (4).

6. Replace battery (see Battery Replacement Proce-

dure, page 9).

7. Install the electronic control to the metering unit (4),

aligning the longer screws boss on the meter hous-

ing with the counter bore in the plastic housing.

8. Install the four screws (3) holding the electronic con-

trol (1) to the metering unit (4) together. Torque the

screws to 15-20 in-lb (1.7 to 2.3 N•m) or until no gap

exists between the electronic control and the meter-

ing unit.

NOTICE

To avoid pinching the battery wires, install the bat-

tery as shown in F

IG. 5. The battery wire should

extend to the far side of the battery compartment.

NOTICE

Closing the gap between the electronic control and

the metering unit is very important; it ensures that

no moisture can enter the electronics.