Graco IM5 239824 [9/14] Battery replacement procedure

Service

308687J 9

Battery Replacement Procedure

IG. 5)

1. Relieve Pressure, (see procedure in previous sec-

tion).

2. Remove the four screws (3) holding the electronic

control (1) and metering unit (4) together.

3. Remove the battery.

4. Install the new battery.

NOTE: See Technical Data, page X for recommended

batteries.

5. Install the electronic control to the metering unit (4),

aligning the longer screws boss on the meter hous-

ing with the counter bore in the plastic housing.

6. Install the four screws (3) holding the electronic con-

trol (1) to the metering unit (4) together. Torque the

screws to 15-20 in-lb (1.7 to 2.3 N•m) or until no gap

exists between the electronic control and the meter-

ing unit.

Electronic Control Replacement

Procedure (F

IG. 6)

1. Relieve Pressure, (see procedure in previous sec-

tion).

2. Remove the four screws (3) holding the electronic

control (1) and metering unit (4) together.

3. Remove the battery. (See Battery Replacement Pro-

cedure in the previous section).

FIG. 5

NOTICE

To avoid pinching the battery wires, install the bat-

tery as shown in F

IG. 5. The battery wire should

extend to the far side of the battery compartment.

NOTICE

Closing the gap between the electronic control and

the metering unit is very important; it ensures that

no moisture can enter the electronics.

FIG. 6