Moxa ioLogik 2542-T [16/88] Installing the iologik 2500 on a din rail

ioLogik 2500 Series Installation

2-2

Hardware Installation

Installing the ioLogik 2500 on a DIN Rail

The DIN-rail attachment plate should already be fixed to the back panel of your ioLogik 2500. If you need

to reattach the plate, be sure the spring-loaded bracket is oriented towards the bottom, as shown in the

figures below.

STEP 1: If the spring

-loaded bracket is locked in place,

push the recessed button to release it

. Once released,

you should feel some resistance from the spring as you

slide the bracket up and down a few millimeters in each

direction.

STEP 2: Insert the top of the rail into the upper lip

of the attachment plate’s slot.

STEP 3: The attachment unit

should now snap into

place along the rail, as shown below.

Removing the ioLogik 2500 from a DIN Rail

To remove the ioLogik 2500 from a DIN rail, use a

screwdriver to pull down the spring

-loaded bracket

until it locks in place, as shown in the

diagram at

the right. Next, rotate the bottom of the ioLogik

2500 upwards until you can remove it from the DIN

rail.

WARNING

This equipment is intended to be used in Restricted Access Locations. External metal parts

will

hot! Maintenance personnel should wear protective gear before touching the outside surface.