Moxa MxNVR-IA8-T [22/61] Wiring the di do

Moxa MxNVR-IA8 Getting Started

2-11

ATTENTION

The power supply used for this product is the Listed Power Unit, with LPS-marked, 12 to 32 VDC power output.

ATTENTION

Before connecting the VPort to the DC power inputs, make sure the DC power source voltage is stable.

Wiring the DI/DO

The MxNVR-IA8 comes with a 6-ch digital input and a 2-ch digital output through a terminal block connector.

DI Dry Contact Wiring DI Wet Contact Wiring DO Wiring

10/100/1000BaseT(X) Ethernet Port Connection

The 10/100/1000BaseT(X) port located on the MxNVR-IA8 rear panel is used to connect to Ethernet-enabled

devices.

The following table shows the pinouts for both MDI (NIC-type) ports and MDI-X (HUB/Switch-type) ports. We

also show cable wiring diagrams for straight-through and cross-over Ethernet cables.

10/100BaseT(X) RJ45 Pinouts

(MDI) Port Pinouts (MDI-X) Port Pinouts 8-pin RJ45

Pin Signal

1 Tx+

2 Tx-

3 Rx+

6 Rx-

Pin Signal

1 Rx+

2 Rx-

3 Tx+

6 Tx-

1000BaseT RJ45 Pinouts

Pin MDI MDI-X

1 BI_DA+ BI_DB+

2 BI_DA- BI_DB-

3 BI_DB+ BI_DA+

4 BI_DC+ BI_DD+

5 BI_DC- BI_DD-

6 BI_DB- BI_DA-

7 BI_DD+ BI_DC+

8 BI_DD- BI_DC-