Moxa MxNVR-IA8-T [9/61] 100 1000mbps ethernet port

Moxa MxNVR-IA8 Introduction

1-5

Off Hard disks are not connected

FAULT RED

3 conditions could cause the LED to light up:

• Video source is loss

• Network is disconnected

• Hard disks are failed

Off No fault has occurred

V1 V2

V3 V4

V5 V6

V7 V8

GREEN

On Video source is in recording

Off Video source is not recording

LAN

AMBER

On 10/100 Mbps link is active

Blinking Data is being transmitted at 10 Mbps

Off 10/100 Mbps link is inactive

GREEN

On 1000 Mbps link is active

Blinking Data is being transmitted at 1000 Mbps

Off 1000 Mbps link is inactive

10/100/1000Mbps Ethernet Port

The MxNVR-IA8 has one RJ45 10/100/1000M Ethernet port (LEDs on the front panel will show the connection

to be 10/100M or 1000M).

RS-232/RS-422/RS-485 COM ports (reserved for future use)

Two RS-232/422/485 COM ports are located on the rear panel. The two COM ports are reserved for the future

use.

Pin RS-232 RS-422 RS-485 (4-wire) RS-485 (2-wire)

1 DCD TxDA(-) TxDA(-) –

2 RxD TxDB(+) TxDB(+) –

3 TxD RxDB(+) RxDB(+) DataB(+)

4 DTR RxDA(-) RxDA(-) DataB(-)

5 GND GND GND GND

6 DSR – – –

7 RTS – – –

8 CTS – – –

24 VDC Power Input

The MxNVR-IA8 can be powered by a DC power input from 12 to 32 VDC. Users can check the PWR LED status

located on the front panel to see if the power inputs are connected appropriately.