Gorenje SC 1800 R [53/142] Components

Gorenje SC 1800 R [53/142] Components
53
Components
Power "On" Light (red): This light will illuminate
when the unit is plugged into the 220-240V. wall
outlet. It will then turn "green" when the steam is
ready.
CAUTION: Read the instructions
for -Filling the Water Tank" before
opening the Safety Cap.
CAUTION: Always unplug before filling. ALLOW
UNIT TO COOL FOR FIFTEEN (15) MINUTES
BEFORE REFILLING.
IMPORTANT: Do NOT add cleaning solutions,
scented perfumes, oils or any other chemicals to the
boiler in this appliance. Use tap water or
distilled/purified water if the tap water in your area is
very hard.
Filling or Refilling Your Steam
Cleaner With Water
IMPORTANT: Always insure that the unit is
"UNPLUGGED" from the wall receptacle prior to
initial filling or re-filling the water tank and has been
allowed to cool for 15 minutes. Never attempt to fill
this unit under a water tap. always use the filling
funnel provided.
Step 1: Before refilling the steam cleaner, make
sure that the unit is NOT plugged in and
has been allowed to cool for fifteen (15)
minutes.
Step 2: Press the steam trigger on the hand grip
to vent any residual steam that is in the
boiler.
Step 3: Place the unit on a flat, stable surface.
Slowly turn the safety filler cap counter
clockwise until it is removed.
Step 4: Insert the funnel into the tank opening and
add (800 ml) of water. Place the funnel in
the tank opening as illustrated in Fig. 1.
The funnel has been specially designed to
show when the water tank is full. When
water starts to come out of the vent hole
of the funnel, the tank is full. Remove the
funnel slowly and let the remaining water
in it to go inside the water tank. Do Not
Overfill. Replace the Safety Cap.
WARNING: Allow unit to cool for 15 minutes before
refilling.
Vent hole
When refilling the steam cleaner while the boiler is
still hot, there is a risk that water will squirt back
during filling and cause scalding. Extreme care
should be taken when refilling the unit. Use caution
when opening the Safety Cap as cap may become
hot during use and escaping steam can cause
scalding.
Step 5: Connect desired attachments onto the
Flexible Steam Hose.
Step 6: Plug the unit into a standard (220-240
volt, grounded) wall receptacle. Allow
approximately 8-10 minutes for vapor to
reach its working temperature and
pressure. When the unit is ready for use,
the red light will change to green. Always
point nozzle outlet in a safe direction. At
the start, some water will come out from
the nozzle. This is normal.
NOTE: When the steam cleaner has run out of
water, steam output will cease.
5

Содержание