Loewe BluTech Vision [27/33] Troubleshooting

27 -

Troubleshooting

Problem Possible Cause Remedy

Not working at all Mains cable not plugged in. Firmly plug the mains cable into the Player and into a socket.

No picture. TV not switched to receiving signals from the Player. Select the suitable video input mode on the television so that the

picture from the Player is shown on the television screen.

HDMI cable not properly connected. Connect HDMI cable properly.

The connected television is switched off. Switch the TV on.

No sound. The audio equipment has not been switched to Player

Adjust the audio receiver so that you can hear the sound playback

is lit up.).

A disc that can not be played has been inserted. Insert a playable disc (Check the disc type, the colour system and the

regional code).

The disc has not been inserted with the playable side

facing down.

Insert the disc with the playable side facing down.

The disc has not been inserted in the groove.

Place the disc correctly in the groove in the disc drawer.

Dirt on disc. Clean the disc.

Safety level of parental control set. Cancel the safety level or change the parental control.

The remote control is not working properly.

The batteries in the remote control are dead. Replace the batteries with new ones.

The settings have been deleted.

Due to a power failure the unit was disconnected from

Always switch the unit off using the ON / OFF switch.

Forgotten PIN code for parental protection.

Hold the ON / OFF button pressed until RESET appears.