Aten CS1922 [17/51] Hardware setup

Chapter 2

Hardware Setup

Cable Connections

To set up your installation, refer to the installation diagram on the following

page (the numbers in the diagram on page 11 correspond to the steps below),

and do the following:

1. Plug the USB keyboard and USB mouse into the USB console ports

located on the unit’s rear panel.

2. Plug the console monitor into the DisplayPort console port located on the

unit’s rear panel and power on the monitor.

3. Plug the main microphone and speakers into the console microphone and

speaker jacks located on the unit’s front panel. The microphone and

speakers plugged into this port have priority over those in the rear panel.

4. (Optional) Plug your secondary microphone and speakers into the console

audio ports located on the unit’s rear panel.

5. Using the cables provided with this package, plug the DisplayPort, USB

3.0, microphone, and speaker connectors into their corresponding sockets

in the KVM Port section of the switch.

Note: Verify that all the plugs are in the same KVM Port sockets (all in

Port 1, all in Port 2, etc.), and that each socket is marked with an

appropriate icon to indicate itself.

6. At the other ends of the cables, plug the DisplayPort, USB 3.0,

microphone, and speaker connectors into their respective ports on the

computer.

1. Important safety information regarding the placement of this

device is provided on page 35. Please review it before

proceeding.

2. Make sure that power to all the devices you will be installing has

been turned off. You must unplug the power cords of any

computers that have the Keyboard Power On function.