Aten VS461 [13/19] Installation

- 13 -

Installation

Refer to the installation diagram (the numbers in the diagrams

correspond to the numbers of the steps) and do the following:

1. Plug your DVI display's connector into the Video Output port

located in the Output section on the unit's rear panel.

2. Plug your speakers into the audio jacks (left and right) located

in the Output section on the unit's rear panel.

3. Use a DVI cable to connect the source device's video out port

to any available DVI socket on the Input section of the switch.

4. Use audio cables to connect the source device's audio out

ports into the VS-261 / VS-461's audio jacks.

Note: Be sure that the audio cables plug into the jacks that

correspond to the port that the DVI connector is plugged

into (i.e., all cables are in Port 1 sockets, or all in Port 2

sockets, etc.).

5. Plug the power adapter that came with your switch into an AC

power source, then plug the power adapter cable into the

switch's Power Jack.

This completes the installation. Once the switch is powered up,

you can power on the source devices.

1. Make sure that the power to any device that you

connect to the installation has been turned off. You

must unplug the power cords of any computers that

have the Keyboard Power On function.

2. Make sure that all devices you will be installing are

properly grounded