Aten VC010 [15/39] Hardware setup

Chapter 2

Hardware Setup

Installation

Installation of the VC010 / VC060 / VC080 is simply a matter of plugging in

the appropriate cables.

To install the VC010 / VC060 / VC080, refer to the installation diagram in the

next page as you perform the following steps:

1. Do the cable connection for your device as follows:

 For VC010, use a HDB-15 cable to connect the VGA input port on the

video display device to the VGA Out port on the rear of the VC010.

 For VC060, use a DVI cable to connect the DVI input port on the

video display device to the DVI Out port on the rear of the VC060.

 For VC080, use an HDMI cable to connect the HDMI input port on the

video display device to the HDMI Out port on the rear of the VC080.

2. Connect the source device(s) to the front panel port, as follows:

 For VC010, use an HDB-15 cable to connect the VGA source

device(s) to the VGA In port on the VC010.

 For VC060, use a DVI cable to connect the DVI source device(s) to the

DVI In port on the VC060.

 For VC080, use HDMI cables to connect the HDMI output ports on the

source device(s) to the HDMI In port on the VC080.

3. Plug the Plug the USB to DC Power Cord cable into the power jack on the

into the Power Jack on the VC010 / VC060 / VC080.

1. Important safety information regarding the placement of this

device is provided on page 27. Please review it before

proceeding.

2. Make sure that the power to all devices connected to the

installation are turned off.

3. Make sure that all devices you will be installing are properly

grounded.