Indesit IN CH 310 AA VE I [22/60] Troubleshooting

Indesit IN CH 310 AA VE I [22/60] Troubleshooting
22
GB
Troubleshooting
If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the
following list.
Malfunctions:
The display does not illuminate.
The motor does not start.
The refrigerator and the freezer do not
cool well.
The food inside the refrigerator is
beginning to freeze.
The motor runs continuously.
The appliance makes a lot of noise.
There is water at the bottom of the
refrigerator.
Door open alarm.
Abnormal freezer heating alarm.
Possible causes / Solutions:
The plug has not been inserted into the electrical socket, or not far enough
to make contact, or there is no power in the house.
The appliance comes with a motor protection control (see Start-up and use).
The doors do not close properly or the seals are damaged.
The doors are opened too frequently.
The OPERATION knobs are not on the correct setting (see Description).
The refrigerator or the freezer have been over-filled.
The REFRIGERATOR OPERATION knob is not on the correct setting (see
Description).
The food is in contact with the back inside wall of the refrigerator.
The SUPER COOL and/or SUPER FREEZE and/or ICE PARTY functions are
enabled (see Description).
The door is not closed properly or is continuously opened.
The outside ambient temperature is very high.
The internal refrigerant makes a slight noise even when the compressor is
off. This is not a defect, it is normal.
The water discharge hole is blocked (see Maintenance).
Should the refrigerator door be left open for more than two minutes, the lamp
inside the compartment will begin to flash; after a few seconds, an alarm
buzzer is sounded. To silence this buzzer, just shut the door or press the
SELECT button. Should the door remain open for more than 4 minutes, the
lamp will flash more rapidly.
1. To signal an excessive heating on the part of the freezer (e.g. momentary power
failure), a buzzer will sound and a message comes up on the display A1 to
signal the dangerous heating of the compartment. To prevent food from
refreezing, the freezer will try to maintain a temperature of 0°C, thus allowing
you to use up the food within 24 hours or to cook them and then refreeze them.
You can turn the buzzer off simply by pressing the SELECT button.
To return to normal operation and cancel the message from the display, you
need to turn the appliance off and on again, turning the appliance FREEZER
OPERATION and APPLIANCE ON/OFF Knob.
1. If the temperature inside the freezer continues to rise to excessively high values,
the buzzer will sound yet again and another message
A2A2
A2A2
A2will come up on the
display to signal the dangerous state of overheating. We recommend you check
the conditions of the food, as it may be necessary to throw it away. In all cases,
food should not be refrozen unless you cook it first. To prevent food from
refreezing, the freezer will try to maintain a temperature of 0°C. The buzzer can
be turned off by simply pressing the SELECT button. To return to normal
operation and cancel the message from the display, you need to turn the
appliance off and on again, turning the appliance FREEZER OPERATION and
APPLIANCE ON/OFF Knob.

Содержание

Troubleshooting If the appliance does not work before calling for Assistance see Assistance check for a solution from the following list Malfunctions Possible causes Solutions The display does not illuminate The plug has not been inserted into the electrical socket or not far enough to make contact or there is no power in the house The motor does not start The appliance comes with a motor protection control see Start up and usé The refrigerator and the freezer do not cool well The doors do not close properly or the seals are damaged The doors are opened too frequently The OPERATION knobs are not on the correct setting see Description The refrigerator or the freezer have been over filled The food inside the refrigerator is beginning to freeze The REFRIGERATOR OPERATION knob is not on the correct setting see Description The food is in contact with the back inside wall of the refrigerator The motor runs continuously The SUPER COOL and or SUPER FREEZE and or ICE PARTY functions are enabled see Description The door is not closed properly or is continuously opened The outside ambient temperature is very high The appliance makes a lot of noise The internal refrigerant makes a slight noise even when the compressor is off This is not a defect it is normal There is water at the bottom of the refrigerator The water discharge hole is blocked see Maintenance Door open alarm Should the refrigerator door be left open for more than two minutes the lamp inside the compartment will begin to flash after a few seconds an alarm buzzer is sounded To silence this buzzer just shut the door or press the SELECT button Should the door remain open for more than 4 minutes the lamp will flash more rapidly Abnormal freezer heating alarm 1 To signal an excessive heating on the part of the freezer e g momentary power failure a buzzer will sound and a message comes up on the display A1 to signal the dangerous heating of the compartment To prevent food from refreezing the freezer will try to maintain a temperature of 0 C thus allowing you to use up the food within 24 hours or to cook them and then refreeze them You can turn the buzzer off simply by pressing the SELECT button To return to normal operation and cancel the message from the display you need to turn the appliance off and on again turning the appliance FREEZER OPERATION and APPLIANCE ON OFF Knob 1 If the temperature inside the freezer continues to rise to excessively high values the buzzer will sound yet again and another message A2 will come up on the display to signal the dangerous state of overheating We recommend you check the conditions of the food as it may be necessary to throw it away In all cases food should not be refrozen unless you cook it first To prevent food from refreezing the freezer will try to maintain a temperature of 0 C The buzzer can be turned off by simply pressing the SELECT button To return to normal operation and cancel the message from the display you need to turn the appliance off and on again turning the appliance FREEZER OPERATION and APPLIANCE ON OFF Knob 22