Timberk swh rs1 80 vh [9/40] Water heater control

Timberk swh rs1 80 vh [9/40] Water heater control
www.timberk.com • electrical storage water heater
9
IMPORTANT!
- if pressing test button (2) voltage is not cut off and/or
indicator (1) continues to be lighted, it means that GFCI
safety device is not operating properly.
- if pressing restart button (3) voltage is not restored
and/or indicator (1) doesn’t light up, it means that the
water heater is not operating properly. In both cases
disconnect the water heater and call the service center.
- to reduce the risk of an electric shock, do not
disassemble, remove or fill liquid in this appliance.
8. WATER HEATER CONTROL
Control panel for the following models:
SWH RS1 30 VH
SWH RS1 50 VH
SWH RS1 80 VH
SWH RS1 100 VH
Fig. 8
Indication light
Indication thermostat
handle
SWH RS1, SWH RS2 series
1. At first, open one of the discharge valves on the outlet of the water
heater, then open the inlet valve. The electric water heater will start filling
with water. When water flows from the outlet valve freely, it means the water
heater is fully filled with water and you can close the discharge tap.
Warning: During normal operation the inlet valve must be set «open».
2. Plug the power cord into the outlet, an indicator light will light up.
3. The appliance can automatically control water temperature. When
water temperature in the water heater reaches the temperature, set by the
user, the heating is automatically switched off, and water temperature will
be maintained due to the heat insulation layer; when water temperature
drops to a certain level, heating is automatically switched off, in such a
way continuous hot water supply is provided. When the water heater
automatically switches off, the indicator light goes out.
4. If you will turn the thermostat handle clockwise, you’ll increase the
temperature of heating. Maximum temperature inside inner tank is +75°C
approx. If you want to reduce the temperature of water, please, turn the
handle anticlockwise.
5. If you choose position of thermostat handle like «optimum» or « » , it
means you choose the most comfortable water temperature +58 °(±2 °C).
9. WATER HEATER OPERATION
IMPORTANT!
Power outlet must be designed for rated current not
less than 10A, copper stranded power cord not less
than 3 x 1.5 mm
2
in cross section (for copper).
Power plug of the appliance represents a single unit
with GFCI*.

Содержание