Pilotage Автомодель Monster ONE RTR 4WD 1/10 (RC16588) [20/48] Advice when running on rough surfaces

www.pilotage-rc.com

Cornering

• Prior to entering a corner smootnly reduce your speed to the point where the model maintains traction

and does not slide laterally while in a turn. While conrnering maintain the throttle to keep your RPMs up to

resume acceleration quickly once the cornering has been completled and so that tourqe on the wheels is

constantly present.

• Once the model has reduced its speed, evenly angel the model into the curve. Select a trajectory so that the

shapest pont of the inside edge of the curve is in the center of your models curve line as illustrated in the

diagrams above. This point is called the apex of the turn. Select a path so that the model will come closest

to the apex while maintaining as wide a turn radius as possible. Once the model passes the apex gradually

begin to streightn out the wheels and smoothly increase speed and prepair for your next turn in the course.

• Never make sharp or jerky motions while cornering. Doing so will only risk ipping your model or

signicantly reducing your speed while unessesarily cutting down on your intertia.

Jumping

• While performing jumps you can adjust your model’s orientation in the air.

• In order to lift the nose of your model while jumping, increase the rpms of your motor.

• In order to lower the nose of your model, activate the breaks while airborne.

• In order to slightly adjust the left/right trajectory of your model, turn the tires of the model in the desired

directon.

• When landing the wheels on the model should be straight.

In most cases jumps should be approached in the following manner:

• Build up enough speed to travel through the air between the jump gap.

• Hold the speed level stable while approaching the incline on the jump.

• Once the front tires touch the beginning of the incline drop the throttle and allow the intertia to carry the

model through the air.

• Once the jump is complete smoothly increase the throttle and continue on your way.

Advice when running on rough surfaces

When running on uneven surfaces keep your traction buy puming the throttle. Keep the RPMs of the model

constant but pump the gas to maintain the speed rather than holding a constand level on the throttle. You

should see immediate improvement due to this.