Freggia CHPA6GTB [10/40] Installation instructions

INSTALLATION INSTRUCTIONS

Attention!

Assembly and electrical connections must be carried out by specialised personnel.

Attention!

Wear protective gloves before proceeding with the installation.

ELECTRIC CONNECTION

The appliance has been manufactured as a class II, therefore no earth cable is necessary.

The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral

If not provided, connect a plug for the electrical load indicated on the description label. Where a plug is provided, the

cooker hood must be installed in order that the plug is easily accessible.

An omnipolar switch with a minimum opening of 3mm between contacts, in line with the electrical load and local

standards, must be placed between the appliance and the network in the case of direct connection to the electrical

network.

The distance between the supporting surface of the cooking appliance on which the cooking recipients are placed

and the lower part of the kitchen hood must be a minimum of 45 cm, whether it is an electric hob, a gas hob or an

induction hob). If a connection tube composed of two parts is used, the upper part must be placed outside the lower

part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes

from other appliances generated by other than an electrical source.

• In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.

We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe

with a smaller diameter is used, the e ciency of the product may be reduced and its operation may become noisier.

Before proceeding with the installation, to be able to move the hood more easily, complete the following

operations:

1. Remove the anti-grease  lterl by pulling the handle, as shown in  gure 2 - phase 1.

2. If the product is equipped with activated charcoal  lters (B-C), remove them as shown in  gure 2 - phase 2B or 2C.

3. Unhook the small cupola M as shown in  gure 2 - phase 4.

FIXING TO THE WALL (FIG.3):

Mark the position of the lower side of the hood on the wall  gure 3 - phase 1 (taking into account the minimum

distance required from the hob).

Position the  xing template on the wall, making sure that the line coincides with the line previously made on the wall,

as described in the preceding section.

Mark and drill  xing holes  gure 3 - phase 2.

Fasten the 4 anchors and the 2 screws A-B without fully tightening them  gure 3 - phase 2.

Position the appliance on the wall and permanently secure it by pulling the 2 screws B  gure 3 - phase 3-4 and the 2

locking screws B  gure 3 - phase 5.

When carrying out the  xing operations, use only screws and screw anchors suited to the type of wall (e.g. reinforced

concrete, plasterboard etc.).

If the screws and screw anchors are supplied with the appliance, make sure that they are suited to the type of wall to

which the hood must be  xed.

INSTALLATION INSTRUCTIONS