Polaris ORION S 5.5 (душ) [14/21] Essential recommendations

It forbidden:

• to leave the operating unit without supervision;

• to use a damaged unit (control panel damage, power cord or power supply damage);

• to remove the front cover, while the unit is switched in the electric circuit;

• to set a stop valve in the hot water outlet.

• to make the adjustment of any devices, except the water supply with valve head;

• to switch on the appliance if there is a possibility of the freezing of water in the water heater;

• to plug on the appliance if you don’t use it for a long time.

Function and field of application

• A function of the electric instant water heater is to supply hot water to user, while he is at

home, at the country side or at any other place.

• The reliability of operation and service life of the unit are proved by years of manufacture

experience according to European standards, advanced technologies and modern constructional

materials.

• The up-to-date bio-design let you install the unit in every interior successfully.

Installation

The shower water heater is set on the wall at an altitude much greater than a person's height. The

water heater is completed with a bibb (tap-goose) and is fastened on the wall above the sink.

While using the water heater watch the water not to drop on it.

Installation arrangements are made on the account of the person who buys it.

The Producer is not responsible for the defects caused by wrong setting or careless usage of

the following operating manual.

It is necessary to set up the water heater only by a specialist with necessary qualification.

Essential recommendations

1. The water heater should be set up by a qualified electrician.

2. On the electrical control panel must be set a special automatic device. To make the water

heater work it is necessary to have the water pressure -1/4 bar and the power of the water flow

from 2 till 11 liters per minute. The given water heater can work at the minimum water

pressure -1/4 bar and up to the maximum pressure -about 6 bars.

Scheme 1. Electrical wire-lead termination