Polaris ORION S 5.5 (душ) [18/21] Unit cleaning
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Polaris ORION S 5.5 (душ) [18/21] Unit cleaning

Polaris ORION S 5.5 (душ) [18/21] Unit cleaning
18
There are common installation problems:
Problem Reason and solving method
When the water is very hot,
but only for a short time,
and then the water becomes
very hot again briefly but
for a short time also.
It means that the heater has been installed incorrectly and that
the outlet is being obstructed by some tap or other object. The
tap must be located at the inlet of the heater! Use only the parts
supplied with the heater at the outlet!
The heater heated the water
as expected, but only for a
short time and not again.
The protective fuse blew out, because it was unsuited to the
power of the heater installed.
The heater is not heating. Check to be sure that only parts supplied with the heater are
attached at the outlet! Make sure that the tap at the inlet is a
regular one, not a brass ball faucet/level tap, so that the water
flow can be finely controlled.
Common malfunctions that occur after prolonged, normal use of the heater
The water is very hot
The water temperature can be reduced at the outlet by one of
the following actions:
• the water temperature can be lowered by setting different
levels with “power selector”, going from a maximum supply to
a lower level;
• the water-flow can also be increased by means of the water
tap located at the heater's inlet; more "holes" can be opened in
the shower head to let more water pass through.
• The filter located at the inlet to the heater should also be
cleaned.
The water is very cold. The water temperature can be increased at the outlet by one of
the following actions:
• the water temperature can be raised by setting different
levels with “power selector”, going from a minimal supply to a
higher level;
• the water-flow can also be decreased by means of the water
tap located at the heater's inlet;
• fewer "holes" can be left open in the shower head to let less
water pass through
The water is spraying out of
the shower head too slowly
and/or in the wrong
direction (not into the
shower).
The "holes" in the shower head must be cleaned.
Unit cleaning
• Wipe it with soft wet cloth. Don’t use solvents or abrasives.
• Don’t scrape the body with hard instruments.
Note: You can help to protect the environment! Please remember to respect the local regulations:
hand in the non-working electrical equipments to an appropriate waste disposal center.

Содержание

Похожие устройства

Скачать