Hatco TF-2005 [3/20] Important safety instructions
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Hatco TF-2005 [3/20] Important safety instructions

Hatco TF-2005 [3/20] Important safety instructions
Form No. TF20M-0603
1
IMPORTANT SAFETY INSTRUCTIONS
WARNINGS
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do not
match, contact a qualified electrician to determine
the proper voltage and size and install the proper
electrical outlet.
To avoid any injury or damage to the unit do not
pull unit by power cord.
To prevent any injury, discontinue use if power
cord is frayed or worn.
For safe and proper operation, the unit must
be located a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could
occur. Do not locate unit under shelving or closer
than 12" (305 mm) from the ceiling.
Allow a minimum of 1" (25 mm) clearance along
the sides. Allow a clearance of 26" (660 mm) along
the front and rear discharge (if equipped)
to ensure proper operation and safety.
Model TF-2030 is designed for “pass-through”
use only. To avoid burning or charring
of materials, adequate clearance must
be maintained from front and back openings.
Do not install any closer than 26" (660 mm)
from either opening.
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
Unit is not waterproof. DO NOT submerge
in water. Do not operate if it has been submerged
in water. Do not steam clean the interior or flood
with water or liquid solution.
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the unit.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or
International fax 414-671-3976.
CAUTIONS
Unit is not weatherproof. For safe and proper
operation locate the unit indoors
where
the ambient air temperature is a minimum
of 70°F (21°C).
To avoid any injury or damage to the unit
do not operate appliance without installation
of supplied legs.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
DO NOT use “Pyrex” glass plates or serving
pieces in the finisher. “Pyrex” glass may break
causing personal injury and/or food
contamination.
Plate/tray will be very hot upon removal;
use oven mitt, protective clothing, or pan gripper
to remove.
Do not remove the glass from the unit for cleaning
purposes. Doing so may cause injury or damage
to the unit.
To avoid any injury or damage locate the unit
at the proper counter height, in an area that
is convenient for use. The location should
be level to prevent the unit or its contents from
accidentally falling, and strong enough to support
the weight of the unit and food.
Do not place anything on top of the unit: doing
so could damage the unit or subject personnel
to injury.
DO NOT use paper or plastic serving pieces
in the finisher. These materials may melt or burn
causing a fire hazard and/or food contamination
and may damage the unit.
IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.

Содержание

Похожие устройства

Скачать