Hatco TF-2005 [8/20] Installation

Hatco TF-2005 [8/20] Installation
Form No. TF20M-0603 6
INSTALLATION
UNPACKING
1. Remove unit from box.
2. To prevent delay in obtaining warranty coverage, fill
out and mail in warranty card.
3. Remove tape and protective packaging from all
surfaces of unit.
4. Place wire plate rack on top of rack supports,
making sure plate rack is not in direct contact with
glass base. (See Figure 5.)
LOCATION
WARNING
To avoid any injury or damage to the unit do not
pull unit by power cord.
WARNING
To prevent any injury, discontinue use if power cord
is frayed or worn.
WARNING
For safe and proper operation, the unit must
be located a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
Do not locate unit under shelving or closer than
12" (305 mm) from the ceiling.
WARNING
Allow a minimum of 1" (25 mm) clearance along
the sides. Allow a clearance of 26" (660 mm) along
the front and rear discharge (if equipped) to ensure
proper operation and safety.
WARNING
Model TF-2030 is designed for “pass-through” use
only. To avoid burning or charring of materials,
adequate clearance must be maintained from front
and back openings. Do not install any closer than
26" (660 mm) from either opening.
CAUTION
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the ambient
air temperature is a minimum of 70°F (21°C).
CAUTION
To avoid any injury or damage locate the unit
at the proper counter height, in an area that
is convenient for use. The location should be level
to prevent the unit or its contents from accidentally
falling, and strong enough to support the weight
of the unit and food.
CAUTION
Do not place anything on top of the unit; doing
so could damage the unit or subject personnel
to injury.
Figure 5. Rack Support Placement

Содержание

Похожие устройства

Скачать