Retigo Hold-o-mat standard с термощупом [6/18] Commissioning

OPERATING MANUAL FOR RETIGO HOLD-O-MAT

ver. EN-01/10/12

- Dismantle the two earth plates and t them on the

opposite side.

- Slide the main insulation forwards again and slide

the casing into the front panel.

- Securely tighten all six screws on the rear panel. -

Securely tighten the screw which holds the casing in

position at the bottom front.

- Unscrew the upper hinge pins and t them on the

opposite side.

- On the side of the door on which the door hinge

sleeves are tted, remove the cover caps located on the

inside of the door. Remove the cover caps on the narrow

side of the door.

- Lever the door hinge sleeves out of the holes using

a suitable slotted screwdriver and t them on the

opposite side. Ret the cover caps on the narrow side

and the inside of the door.

The door must not be tted upside down, as in this

case the dehumidication vent would no longer be in

the optimum position. Therefore, the door handle must

also be repositioned. To do this, dismantle the door

handle and t it on the opposite side. Rehinge the door

on the upper door hinge pin and secure it by rmly

tightening the lower door hinge.

4. Commissioning

Connect the power cable to a socket with a 230V/

50/60Hz supply.

Before using for the rst time, it is imperative that

the white protective lm be removed. In addition, we

recommend that the unit be dusted inside and out, with

a damp cloth.

Do not allow magnetic data carriers such as

diskettes, credit cards, cheque cards, ID cards

with magnetic strips, magnetic tapes or watches

to come within 0.5 m of the unit.

Customer service staff with active physical aids

(such as heart pacema kers) must observe a

safety distance of at least 0.5 m from the unit.

The customer service operator must ensure that

all other people with active physical aids (such

as heart pacemakers) observe a safety distance

of at least 0.5 m from the unit.