Siemens TE501203RW [11/117] Settings

Siemens TE501203RW [11/117] Settings
11
en
9. Pull out the milk frother (6) to open it.
LED
F ashes.
10. Water will now ow through the lter and
rinse it.
11. When LED
F lights up constantly,
press in the milk frother (6) to close it.
12. Empty the container.
The appliance is ready to use again.
Information: Rinsing the lter simultane-
ously activates the setting for the change
lter display (= LED D ashes).
The lter is no longer effective when the
change lter display appears, or at the
latest after two months. It needs to be re-
placed for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance). Replacement lters
can be obtained from retailers (TZ70003) or
from customer service (467873). If no new
lter is inserted, change the setting for the
lter (see "Water hardness”).
Information: You can use the lter indicator
to mark the month in which you inserted the
lter. You can also mark the month in which
you will need to replace the lter next (at
the latest after two months).
Information: If the appliance has not been
used for a prolonged period (for example,
when you are on vacation), the existing lter
should be rinsed before the appliance is
used again. To do so, dispense a cup of hot
water and pour it away.
Settings
You can customize the settings on the
appliance.
You can make the following adjustments:
Water hardness
The water hardness setting can be adjusted
on this appliance. It is important to set the
water hardness correctly so that the ap-
pliance can accurately indicate when it is
time to run the descale process. The factory
setting for the water hardness is 4. You can
establish the water hardness either by us-
ing the test strip provided or by asking your
local water provider.
Dip the test strip in the water briey, shake it
gently and check the result after one minute.
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
If you wish to change the default degree of
water hardness, or if you have inserted a
water lter, proceed as follows:
1. Turn the rotary
knob (13) to position
2. Press and hold buttons B (11) and A
(12) simultaneously for at least 5 seconds.
The set water hardness is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeat-
edly until the required water hardness
is indicated, e. g., for water hardness 3,
LEDs D, E and F will light up.

Содержание

Скачать