LifeGear 93800 Инструкция по эксплуатации онлайн [18/22] 297108

the MODE button to select DST (DISTANCE) which displays on the screen. Press the SET

button until you see the DST (DISTANCE) begin blinking. Press the SET button to set the

target distance, each time you press the SET button DST (DISTANCE) should change by

1.0 km. Press the RESET button to clear the target distance to zero. The pre-set target

distance range is from 0.0 to 999.0 kms. Once you pre-set target distance and then start to

exercise, distance starts counting down from pre-set target distance to 0.0. When the

pre-set target distance counts down to 0.0, distance will start to count up and the computer

will beep to alert you.

CAL (CALORIE): Displays the total accumulated calories burned during workout. You may

also pre-set target calories in STOP mode before training. To set CAL (CALORIE) press

the MODE button to select CAL (CALORIE) which displays on the screen. Press the SET

button until you see the CAL (CALORIE) begin blinking. Press the SET button to set the

target calories, each time you press the SET button CAL (CALORIE) should change by 1.0

calorie. Press the RESET button to clear the target calories to zero. The pre-set target

calories range is from 0.0 to 999.0 calories. Once you pre-set target calories and then start

to exercise, calories start counting down from pre-set target calories to 0.0. When the

pre-set target calories count down to 0.0, calories will start to count up and the computer will

beep to alert you. (This data is a rough guide for comparison of different exercise sessions

and should not be used in medical treatment).

PULSE: Displays your current heart rate figures after you grip the handlebar sensors with

both your hands during exercise. To ensure the pulse readout is more precise, please

always hold on to the handlebar grip sensors with two hands instead of just with one hand

only when you try to test your heart rate figures. You may also pre-set target heart rate in

STOP mode before training. To set PULSE press the MODE button to select PULSE which

displays on the screen. Press the SET button until you see the PULSE begin blinking.

Press the SET button to pre-set target heart rate. Press the RESET button to clear the

target heart rate to zero. The pre-set heart rate range is from 40 to 239 beats per minute.

Once you pre-set target heart rate and then start to exercise, please grip the handlebar

sensors with both your hands during exercise. If the heart rate detected greater than the

target heart rate, the computer will beep to alert you.

HOW TO INSTALL THE BATTERIES:

1. Remove the battery cover on the back of the computer.

2. Place two size AA batteries into the battery housing.

3. Insure batteries are correctly positioned and battery springs are in proper contact with

batteries.

4. Re-install the battery cover.

5. If the display is illegible or only partial segment appears, remove batteries and wait 15

seconds before reinstalling.