![Makita BJR141Z БЕЗ АКК. и З/У [6/24] Maintenance](/img/pdf.png)
Makita BJR141Z БЕЗ АКК. и З/У [6/24] Maintenance
![Makita BJR141Z БЕЗ АКК. и З/У [6/24] Maintenance](/views2/1365751/page6/bg6.png)
6
removed and the blade clamp sleeve is fixed at the
released position.
1
007387
NOTE:
• If you remove the saw blade without rotating the
blade clamp sleeve fully, the sleeve may not be
fixed. In this case, rotate the blade clamp sleeve
fully, then make the sleeve fixed at the released
position.
OPERATION
007388
CAUTION:
• Always press the shoe firmly against the workpiece
during operation. If the shoe is held away from the
workpiece during operation, strong vibration and/or
twisting will be produced, causing the blade to
snap dangerously.
• Always wear gloves to protect your hands from hot
flying chips when cutting metal.
• Be sure to always wear suitable eye protection
which conforms with current national standards.
• Always use a suitable coolant (cutting oil) when
cutting metal. Failure to do so will cause premature
blade wear.
• If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
Press the shoe firmly against the workpiece. Do not
allow the tool to bounce. Bring the blade into light
contact with the workpiece. First, make a pilot groove
using a slower speed. Then use a faster speed to
continue cutting.
NOTE:
• If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
Replacing carbon brushes
1
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
007389
After replacing brushes, insert the battery cartridge into
the tool and break in brushes by running tool with no
load for about 1 minute. Then check the tool while
running and electric brake operation when releasing the
switch trigger. If electric brake is not working well, ask
your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
1. Brush holder
cap
2. Screwdriver
1. Limit mark
1. Blade clamp
sleeve
Содержание
- Bjr141 1
- Cordless recipro saw scie récipro sans fil sierra de sable inalámbrico 1
- Instruction manual manuel d instruction manual de instrucciones 1
- General safety rules 2
- Save these instructions 2
- Specifications 2
- Specific safety rules 3
- For battery cartridge for battery cartridge 4
- Functional description 4
- Important safety instructions 4
- Installing or removing battery cartridge 4
- Save these instructions 4
- Symbols 4
- Tips for maintaining maximum battery life 4
- Warning 4
- Adjusting the shoe 5
- Assembly 5
- Electric brake 5
- Installing or removing the saw blade 5
- Switch action 5
- Maintenance 6
- Operation 6
- Replacing carbon brushes 6
- Accessories 7
- Caution 7
- Makita limited one year warranty 7
- Plastic carrying case 7
- Recipro saw blades 7
- These accessories or attachments are recommended for use with your makita tool specified in this manual the use of any other accessories or attachments might present a risk of injury to persons only use accessory or attachment for its stated purpose if you need any assistance for more details regarding these accessories ask your local makita service center 7
- Various type of makita genuine batteries and chargers 7
- Conservez ce mode d emploi 8
- R è gles de s é curit é g é n é rales 8
- Sp é cifications 8
- Avertissement 10
- Conservez ce mode d emploi 10
- Consignes de s é curit é importantes 10
- Pour la batterie pour la batterie 10
- R è gles de s é curit é particuli è res 10
- Symboles 10
- Conseils pour obtenir la dur é e de service maximale de la batterie 11
- Conservez ce mode d emploi 11
- Description du fonctionnement 11
- Installation ou retrait de la batterie 11
- R é glage du sabot 11
- Assemblage 12
- Frein é lectrique 12
- Interrupteur 12
- Pose et retrait de la lame de scie 12
- Accessoires 13
- Entretien 13
- Remplacement des charbons 13
- Utilisation 13
- Accessoires ou pièces qu aux fins auxquelles ils ont été conçus si vous désirez obtenir plus de détails concernant ces accessoires veuillez contacter le centre de service après vente makita le plus près 14
- Cette garantie vous donne des droits spécifiques reconnus par la loi et possiblement d autres droits qui varient d un état à l autre certains états ne permettant pas l exclusion ou la limitation des dommages accessoires ou indirects il se peut que la limitation ou exclusion ci dessus ne s applique pas à vous certains états ne permettant pas la limitation de la durée d application d une garantie tacite il se peut que la limitation ci dessus ne s applique pas à vous 14
- Des réparations ont été effectuées ou tentées par un tiers des réparations s imposent suite à une usure normale l outil a été malmené mal utilisé ou mal entretenu l outil a subi des modifications 14
- Garantie limitée d un an makita 14
- Lames de scie récipro 14
- Les divers types de batteries et chargeurs makita authentiques 14
- Mallette de transport en plastique 14
- Especificaciones 15
- Guarde estas instrucciones 15
- Normas generales de seguridad 15
- Advertencia 17
- Guarde estas instrucciones 17
- Instrucciones importantes de seguridad 17
- Normas espec í ficas de seguridad 17
- Para cartucho de bater para cartucho de bater í a 17
- S í mbolos 17
- Consejos para alargar al m á ximo la vida ú til de la bater í a 18
- Descripci ó n del funcionamiento 18
- Guarde estas instrucciones 18
- Instalaci ó n o desmontaje del cartucho de bater í a 18
- Regulaci ó n de la zapata 18
- Accionamiento del interruptor 19
- Freno el é ctrico 19
- Montaje 19
- Para instalar o quitar la segueta 19
- Accesorios 20
- Mantenimiento 20
- Operaci ó n 20
- Reemplazamiento de las escobillas de carb ó n 20
- Cualesquiera otros accesorios o acoplamientos conllevará un riesgo de sufrir heridas personales utilice los accesorios o acoplamientos solamente para su fin establecido si necesita cualquier ayuda para más detalles en relación con estos accesorios pregunte a su centro de servicio makita local 21
- Diferentes tipos de baterías y cargadores genuinos de makita 21
- Garantía limitada makita de un año 21
- Maletín de transporte de plástico 21
- Sierra de sable 21
- Advertencia 24
- Makita corporation 24
- Warning 24
Похожие устройства
- Ryobi ERS80VHG Инструкция по эксплуатации
- Энкор МПЭ-1250/180Э Инструкция по эксплуатации
- Bosch GSA 18 V-LI 4.0Ач Professional Инструкция по эксплуатации
- Кратон WMM-1.5 Инструкция по эксплуатации
- Кратон WMTS-80/55 Инструкция по эксплуатации
- Кратон WMM-0,75 Инструкция по эксплуатации
- Кратон WMTS-6-02 Инструкция по эксплуатации
- Кратон WMTS-6-04 Инструкция по эксплуатации
- Кратон DM-16/375W Инструкция по эксплуатации
- Кратон WMBS-8-02 Инструкция по эксплуатации
- Кратон WMS-750 Инструкция по эксплуатации
- Кратон WMS-5-02 Инструкция по эксплуатации
- Кратон WMS-5-03 Инструкция по эксплуатации
- Ada PROF-X15 Инструкция по эксплуатации
- Thermex CHAMPION ES 80V Руководство по эксплуатации
- Timberk TRR.A EL 1500 WT Инструкция по эксплуатации
- Skil 9955 MA (F 015 995 5NA) Инструкция по эксплуатации
- Timberk TRR.A EL 2400 WT Инструкция по эксплуатации
- Энергомаш ТС-6012Л Инструкция по эксплуатации
- Энергомаш ТС-60152 Инструкция по эксплуатации