D-Link DGS-1024D [10/32] Rear panel description

D-Link DGS-1016TL/DGS-1024TL Gigabit Ethernet Switch

Figure 1-3. LED Indicators

Power

This indicator will light green immediately after the Switch is powered on to indicate

the ready state of the device.

Link/Act

This indicator lights green when the port is connected to a Gigabit Ethernet, Fast

Ethernet, or Ethernet station. If the indicator is blinking green, data is either being

transmitted or received.

1000Mbps

This LED indicator lights green when the port is connected to a 1000Mbps Gigabit

Ethernet station.

100Mbps

This LED indicator lights green when the port is connected to a 100Mbps Fast

Ethernet station.

NOTE: If the Link/Act LED indicator lights green and both of 1000Mbps and

100Mbps LED indicators are off, this means the port is connecting to a 10Mbps

Ethernet station.

Rear Panel Description

The rear panel of the Switch consists of an AC power connector. The following shows the rear panel of the

Switch.

Figure 1-4. Rear panel view of the Switch

The AC power connector is a standard three-pronged connector that supports the power cord. Plug-in the female

connector of the provided power cord into this socket, and the male side of the cord into a power outlet. The

Switch automatically adjusts its power setting to any supply voltage in the range from 100 ~ 240 VAC at 50 ~ 60

Hz.