D-Link DI-514 Инструкция по эксплуатации онлайн [29/60] 41528

TX Rates – Select the data rate. Default is 1-2-5.5-11Mbps.

Preamble Type - Short preamble is the default setting. (High traffic

networks should use the shorter preamble type.) The preamble defines the

length of the CRC block used in communication between the Access Point

and the roaming wireless Network adapters. (Cyclic Redundancy Check is a

common technique for detecting data transmission errors)

Authentication - Select Open system, Shared Key or Auto

Open System - The DI-514 will be visible to all devices on the network. This

is the default setting.

Shared Key - In this mode, in order to access the DI-514 on the network, the

device must be listed in the MAC Address Control List.

Auto - In this mode, all devices on the network can access the

DI-514.

SSID Broadcast - Enable is the default setting. Choose Enable to

broadcast the SSID across the network. All devices on a network must share

the same SSID (Service Set Identifier) to establish communication. Choose

Disable if you do not wish to broadcast the SSID over the network.

Admin

At this page, the DI-514

administrator can change the

system password. There are

two accounts that can access

the Broadband Router’s Web-

Management interface. They

are admin and user. Admin

has read/write access while

user has read-only access.

User can only view the

settings but cannot make any

changes.

Remote Management

Remote Management allows the DI-514 to be configured from the Internet by

a web browser. A username and password is still required to access the

Web-Management interface. In general, only a member of your network can

Tools > Admin