D-Link DP-313 Инструкция по эксплуатации онлайн [11/28] 41545

The print server’s ad-hoc mode supports two modes (802.11 ad-hoc

mode and proprietary ad-hoc mode). You can position the DIP switch

on the print server to the mode you want to operate. Which option of

the ad-hoc mode is required depends on the operation of your print

server. It depends on which ad-hoc mode is supported by your

wireless card driver on the PC/Notebook. Some driver supports both

modes, however, some driver support only one of the modes. The

names of each ad-hoc mode may not be consistent between each

wireless card vendor therefore you may need to try each of the ad-hoc

mode (80.211 mode and proprietary mode) and select the mode that

can communicate with each other.

4. (b) Infrastructure Mode

u Before initiating set-up procedure for the print server make

sure your wireless PCMCIA card on your PC/Notebook is

set to channel 6 with ESS-ID set as ‘default’ in ad-hoc

mode.

u Make sure the DIP switch on the print server is positioned

in the ad-hoc mode.

u Press the Reset button on the print server for three seconds

until the LPT begins to light up initiating the factory reset.

u When factory reset is completed the print server will be set

to default on channel 6 and ESS-ID is set as ‘default’.

u Start-up PS Admin to modify the print server’s ESS-ID to

match with the Access Point’s ESS-ID and this will link the

print server to the Access Point. The ESS-ID uses

“default” as the factory setting.

u From the DIP switch on the print server alter to

infrastructure mode and the print server will reset.

Note 1:

Please make sure to change your PC/Notebook to infrastructure mode.

The ESS-ID on PC/Notebook and print server must match with the

Access Point’s ESS-ID.

Note 2: