Dometic SINEPOWER DSP 424 [19/248] Troubleshooting

SinePower Troubleshooting

10 Troubleshooting

The LED (fig. 2 2, page 3) indicates the fault:

WARNING!

Do not open the device. You risk sustaining an electric shock by doing

this.

NOTE

If you have detailed questions on the specifications of the inverter

please contact the manufacturer (addresses on the back of the instruc-

tion manual).

LED display Cause Remedy

Quick flash Input voltage is too high Check the input voltage and reduce it.

Input voltage too low The battery needs recharging.

Check the cables and connections.

Long flash, short

interruption

Overheating Switch off the inverter and the consumer.

Wait 5 to 10 minutes and switch the inverter

on again without any electric consumers.

Reduce the load and make sure the inverter

has better ventilation. Then switch the con-

sumer back on.

Excessive load Switch off the inverter and remove the

consumer.

Then switch the inverter back on without the

consumer. If no excessive load is now shown,

then there is a short circuit in the consumer or

the total load was higher than the power

specified on the data sheet.

Check the cables and connections.

Off Other fault Contact the service.

DSP200-400--IO-16s.book Seite 19 Donnerstag, 30. November 2017 8:37 08