Epson Stylus Pro XL+ [241/573] Setting page length

Epson Stylus 1500 [241/573] Setting page length
R-10 Set the Printing Area
The margins must be set at the beginning of the line (before any printable
data is sent); otherwise, the printer ignores any data preceding these
commands.
Always set pitch before setting left and right margins. Do not assume what
the pitch setting will be.
The diagram below shows the margins set by sending the following commands
when 8 1/2-inch wide paper is used and the left edge of the paper is at the left-
most mechanically printable position.
ESC @ Resets printer settings
ESC P Selects 10-cpi printing (character width of 1/10 inch)
ESC l 10 Sets a 1-inch left margin
ESC Q 75 Sets a 1-inch right margin
Margin diagram 8 1/2 inches
Setting page length
Because the method of page handling is different, the method for setting the page
length differs for ESC/P 2 and previous ESC/P versions. This section explains
both methods.
ESC/P 2
The ESC/P 2 method of setting the page length allows you to use the same
program for both single-sheet and continuous paper.
The page length setting is effective only when you are using continuous paper.
However, since the printer ignores the setting during single-sheet printing, the
printer is always ready to print on either type of paper.
75 characters
1 inch 1 inch
10 characters

Содержание

Скачать