Epson Stylus Pro XL+ [94/573] Add up the values for all three settings the value for a is this total

Epson Stylus Pro [94/573] Add up the values for all three settings the value for a is this total
Individual Command Explanations C-87
Notes
The data within brackets in the Format section above is repeated for each character you
define.
The format of the attribute byte “a” is different for draft and NLQ characters.
Draft
You can define characters 11-dots wide by 8-dots high. You must specify whether to define
the upper or lower 8 dots of the 9 dots available. You can also specify the columns not
printed on the left and right of the characters during proportional spacing. Set both these
parameters with the a parameter, as described below:
Attribute byte table
Beginning Column Ending Column Upper/Lower 8 pins
Column
number
Value Column
number
Value Pin group Value
0 0 1 1 Upper 8 pins 128
1 16 2 2 Lower 8 pins 0
2 32 3 3
3 48 4 4
4 64 5 5
5 80 6 6
6 96 7 7
7 112 8 8
9 9
10 10
11 11
Add up the values for all three settings; the value for a is this total.
NLQ
The attribute byte a equals the width of the character, between 1 and 12 dot columns.
Only NLQ characters can be defined on LX printers, ActionPrinter Apex 80,
ActionPrinter 2000, ActionPrinter 2250, and ActionPrinter T-1000.
When you switch to NLQ printing on FX printers, the printer enhances user-defined
characters to appear as NLQ-mode characters.
Defining characters during draft or NLQ mode results in the user-defined characters
having the draft or NLQ attribute. You cannot define characters of different attributes at
the same time; previously defined characters will be deleted.
Always cancel italic characters with the ESC 5 command before defining characters.
After defining user-defined characters, you can italicize them by sending the ESC 4
command.
Do not define continuous dots on the same row during draft mode; the printer ignores
the second of two continuous dots.
Send the ESC % 1 command to switch to user-defined characters.
Send the ESC I 1 command to allow you to print the characters between 128 and 159
and the non-control code characters between 0 and 31.

Содержание

Скачать