Fluke 712 [9/16] English instruction sheet page 9

712 English Instruction Sheet

Page

Testing and Replacing the Fuses

WWarning

To avoid personal injury or damage to the

calibrator, use only a 0.125A 250V fast fuse,

Littelfuse 2AG.

Fuse F1 protects the input circuit. Fuse F2 protects the output

circuit. Test and replace the fuses using the following procedure:

1. Remove the test leads from the calibrator terminals and turn

the calibrator off.

2. Remove the battery door.

3. Remove the three Phillips-head screws from the case

bottom and turn the case over.

4. Gently lift the top cover from the end nearest the input/output

terminals until it unsnaps from the bottom cover.

5. Gently remove the fuse from its mounting bracket.

6. Measure the resistance of the fuse. An open or high

resistance suggests that the fuse is blown.

7. Replace the blown fuse with a 0.125 A 250 V fast fuse,

Littelfuse 2AG.

8. Fit the top and bottom covers together, engaging the two

snaps. Make sure that the keypad and the input/output

terminal gasket are properly seated.

9. Reinstall the three screws.

10. Replace the battery door.