Home
Главная
Zanussi
Холодильник
ZBA 3154A
Инструкция по эксплуатации Страница: 41

Zanussi ZBA 3154A [41/64] Maintenance

GGBB

Hints

Saving Energy

Pay careful attention to where the cabinet is placed.

See the section “Installation”. When installed

correctly the cabinet will consume less energy.

Try to avoid keeping the doors open for long periods

or opening the doors too frequently as warm air will

enter the cabinet and cause the compressor to

switch on unnecessarily often.

If the ambient temperature is high, the thermostat

knob is on the coldest setting (higher numbers) and

the appliance is fully loaded, the compressor may

run continuously, causing frost or ice to form on the

evaporator. If this happens, turn the knob to a

warmer setting (lower numbers) to allow automatic

defrosting and so a saving in electricity consumption.

Do not place warm foods inside the appliance. Allow

warm foods to cool first.

Keep the heat emitting condenser, the metall grille on

the rear wall of your appliance, always clean.

Hints for refrigeration

Do not store warm food or evaporating liquids in the

refrigerator and do cover or wrap up the food,

particularly if it has a strong smell.

To help you use your refrigerator correctly, here are some

useful hints:

Raw meat (beef, pork, lamb & poultry): wrap in

polythene bags and place on top of the salad

compartment, this being the coldest spot in the

refrigerator.

Meat can only be stored safely in this way for

one or two days at the most.

Cooked food, cold cuts, jelly, etc.: these should

be well covered and can be stored on any of the

glass shelves.

Fruit & vegetables: these should be thoroughly

cleaned and placed in the bottom drawer/s.

Butter & cheese: these should be placed in special

airtight containers or wrapped in aluminium foil or

polythene bags to keep out as much air as possible.

Milk bottles: these should have a top and should be

stored in the bottle rack on the door.

Bananas, potatoes, onions and garlic, if not

packed, must not be kept in the refrigerator.

Maintenance

Unplug the appliance before carrying out any

maintenance operation.

Warning

This appliance contains hydrocarbons in its cooling unit

maintenance and recharging must therefore only be

carried out by authorised technicians.

Defrosting

Bleeding part of the moisture of cooling chamber in form

of frost and ice goes with the operation of the refrigerator.

Thick frost and ice has an insulating effect, so it reduces

cooling efficiency as the temperature increases, it needs

more energy, at a certain thickness it does not allow the

door of the frozen food compartment to open, possibly

the door can be broken.

At this type of appliance defrosting fresh food

compartment is automatic without any external

intervention.

The thermostatic control interrupts the operation of

compressor at regular intervals for more or less time -

during this cooling is interrupted - temperature of the

fresh food compartment increases and defrosting

occurs. After defrosting the thermostatic control restarts

operation of the system.

Melting water flows through defrost water outlet into the

evaporative tray maintained on the top of compressor and

evaporates due to warmth of it.

Check and clean the outlet of melting water

coming during defrosting regularly. If it is

clogged the melting water gathered can cause

earlier failure as it can go to the insulating of the

appliance.

Clean the melting water outlet with the supplied pipe

scraper that can be seen in the figure. The pipe scraper

has to be stored in the outlet.

Zanussi ZBA 3154A [41/64] Maintenance

Содержание

Похожие устройства