Elenberg DW-9001 [28/41] Adjusting salt consumption

3. Place the end of the funnel (supplied) into the hole and introduce

about 2kg of salt. It is normal for a small amount of water to

come out of the salt container

4. Carefully screw the cap back on.

NOTE:

1. The salt container must be reﬁlled when the salt warning light

comes on. Though the salt container is ﬁlled enough, the indica-

tor light may not black out before the salt fully dissolve.

2. If there are spills of the salt, a soak program could be run to wipe

them out.

Adjusting Salt Consumption

The dishwasher is designed to allow for adjusting the amount of

salt consumed based on the hardness of the water used.

This is intended to optimize and customize the level of salt con-

sumption so that the salt consumption could be set proceed as fol-

lows:

1. Unscrew the cap from the salt container.

2. There is a ring on the container with an ar-

row on it (see Figure to the side), if necessary,

rotate the ring in the anticlockwise direction

from the “-” Setting toward the “+” sign, based

on the hardness of the water being used. lt

is recommended that adjustments should be

made in accordance with the following schema:

WATER HARDNES

Selector

Position

Salt con-

sumption

(gram/

cycle)

Autonomy

(cycles /2

kgs)

Clarke

Degrees

°dH mmol/l

0-14 0-10 0-1.7 - 0 /

14-36 18-44 1.8-4.4 / 20 60

36-71 45-89 4.5-8.9 MED 40 40

71 89 8.9 + 60 25

Contact your local water board for information on the hardness of

your water supply.