Ada ProDigit 60 А00168 — важные инструкции по безопасности для лазерного уровня [28/50]

Превью страниц Страница 28 / 50

MEASUREMENT FOUNDATION

ProDigit 60

Safety instructions

A WARNING: BE SURE to read and understand all instructions in this manual before using this level. Failure to follow all instructions

may result in hazardous radiation exposure, electric shock, re and/or serious personal injury.

SAFETY PRECAUTIONS FOR LASERS

AWARNING: Use of controls, adjustments or performance of procedures other than those specied in this manual may result in hazardous

radiation exposure. AWARNING: The use of optical instruments such as, but not limited to, telescopes or transits to view the laser beam

will increase eye hazard.

This level has a built-in laser light. The laser is a Class2 and emits output power of a maximum 1 mW and 635-665 nm wavelengths. These

lasers do not normally present an optical hazard. However, DO NOT stare at the beam as this can cause ash blindness. A CAUTION: The

following label is on your tool. It indicates level emits the laser light.

BE AWARE of the laser light location. ALWAYS MAKE SURE that any bystanders in the vicinity aware of the dangers of looking directly

into the laser. ДWARNING: LASER RADIATION. DO NOT stare into beam. Class2 laser product.

Only turn laser beam on when the level is on the work surface.

DO NOT remove or deface any product labels. Removing product labels increases the risk of exposure to laser radiation.

DO NOT stare directly at the laser beam or project the laser beam directly into the eyes of others. Serious eye injury could result.

DO NOT place the Laser level in a position that �ay cause anyone to stare into the laser bea� intentionally or uninten-

tionally. Serious eye injury could result.

DO NOT use any �agnifying optical tools such as, but not li�ited to, telescopes or transits to view the laser bea�. Seri-

ous eye injury could result.

DO NOT operate the Laser level around children or allow children to operate the tool. Serious eye injury could result.

ALWAYS turn the Laser level off when not in use. Leaving the tool on increases the risk of so�eone inadvertently staring

into the laser bea�.

DO NOT operate the Laser Level in co�bustible areas such as in the presence of a��able liquids, gasses or dust.

DO NOT use on surfaces such as sheet steel that have a shiny, reective surface. The shiny surface could reect the

bea� back at the operator. Be aware that laser light reected off a �irror or any other reective surfaces can also be

dangerous.

DO NOT place the Laser level in a position that �ay cause anyone to stare into the laser bea� intentionally or uninten-