Bosch WFB 1002 [66/73] Cleaning maintenance frost protection

Содержание

Похожие устройства

GB Cleaning Maintenance Frost protection Cleaning the filters in the water inlet Frost protection Fig The filters in the water inlet must be cleaned if no or insufficient water flows into the machine when the tap is turned ON The filters are located in the hose connection at the tap end and at the back of the machine Cleaning procedure 1 Turn off the tap If the machine is located in a room which is exposed to freezing temperatures any residual water in both the pump and the water inlet hose must be drained immediately every time the machine is used Draining the pump See Cleaning the pump on page 67 Draining the water inlet hose I Turn the tap OFF 2 Set the programme selector to Cottons coloureds normal B and the tempera ture selector to 0 Press the ON OFF but ton After approx 40 seconds switch off the machine by pressing the ON OFF button again This removes the pressure inside the inlet hose 3 Unscrew the hose from the tap and rinse the filter under running water 4 Screw the hose back onto the tap 5 Unscrew the hose at the back of the ma chine 6 Use a pair of flat nosed pliers to remove the filter Clean the filter and replace it inside the hose connection 7 Reconnect the hose 8 Turn on the tap and make sure that no wa ter leaks at either end of the hose 9 Turn off the tap 68 2 Unscrew the hose from the tap and hold the end of the hose over a container 3 Switch ON any of the wash programmes for approximately 40 seconds Water left inside the inlet hose will be drained but 4 Screw the hose back onto the tap