Bosch WFB 1002 [69/73] R removing the transit bolts

Содержание

Похожие устройства

GB r Removing the transit bolts Fig Before the machine is used for the first time it is very important that the transit bolts are removed from the back of the machine Only use the spanner supplied with the ma chine if a ring spanner is unavailable Caution If the spanner slips there is danger of injury 1 Undo and remove the 4 securing bolts A 2 Remove the four spacers B that will have dropped down inside the machine Tilt the machine to the rear so that they fall out 3 Insert the cover caps C which you will find in the bag containing the documentation Keep the transit bolts in case you need to move the machine again moving house Do not transport the machine without first inserting the transit bolts To do this un screw the back panel D and proceed in re verse order 1 and 2 above Installing the machine _____ 71 I When installing and connecting the ma chine special attention must be paid to the safety advice and warnings which have been identified with an exclamation mark I You should comply with all regulations issued by your local water and power autho rities Take care when lifting the machine Risk of injury Do not lift the machine by any of the pro truding parts If in doubt arrange for the machine to be connected by a qualified specialist Before leaving the factory every machine is thoroughly tested under operating conditions Any moisture or residual water which you may find in the machine or drain hose is left over from these tests Installation location To ensure that the machine remains stable while it is spinning the installation location must be flat and solid Do not site the machine on soft floor coverings such as vinyls carpeting or foam backed carpets In the case of timber beam floors place the machine on a water resistant wooden board that is at least 30 mm thick and is screwed to the floor If possible the ma chine should be sited in the corner of a room Secure the machine by attaching retaining straps to the feet this applies particularly if a dryer is going to be placed on top of the washing machine If the machine is installed on a plinth the machine s feet must be secured with retain ing straps to prevent it sliding while it is spinning Retaining straps are available as a set from your authorised dealer 71