Ariston AL 108 D [12/76] Before calling read the following

Ariston AL 108 D [12/76] Before calling read the following
M
ARGHERITA
Margherita - Instructions for installation and use
Before calling, read the following
Troubleshooting
Your washer-dryer could fail to work. In most cases, the problems arising
can be easily solved without having to call for a technician. Before calling
for assistance, always check these points.
The washer-dryer fails
to start.
Is the plug correctly
inserted into the socket? It
could have been moved whilst
cleaning.
Is there electricity in the
house?
A circuit breaker could have
gone off, perhaps because too
many appliances are on at the
same time. Or perhaps because
of a general power failure in
your entire area.
Is the washer-dryer door
closed properly?
For safety reasons, the washer-
dryer cannot work if the door
is open or not shut properly.
Is the On/Off button
pressed?
If it is, then a programmed
start has been set.
Is the programmed start
knob, on those models
concerned, in the correct
position?
Is the water tap open? For
safety reasons, if the washer-
dryer does not load water, it
cannot start a wash cycle.
RIGHT
WRONG
Close the tap
after every wash
cycle.
Limit the use of
the washer-dryers
hydraulic system
and eliminate
leakage risks
when no-one is at
home.
Always leave the
appliance door
ajar to avoid bad
odours.
Clean the
appliances
exteriors
delicately.
To clean the
exteriors and the
rubber parts of
the appliance,
always use a rag
dipped in
lukewarm water
and soap.
Leave the washer-
dryer plugged in while
cleaning.
Even during mainte-
nance, the appliance
should always be
unplugged.
Use solvents and
aggressive abrasives.
Never use solvents or
abrasives to clean the
external and rubber
parts of the washer-
dryer.
Neglect the detergent
dispenser.
It is removable and
can easily be cleaned
by leaving it under
running water.
Go on holiday without
thinking about her.
Before leaving, always
make sure that the
washer-dryer is
unplugged and that
the water tap is
closed.
The washer-dryer
fails to load water.
Is the tap correctly
attached to the pipe ?
Is there a water shortage ?
There could be work in
progress in your building or
street.
Is there enough pressure?
The autoclave may be
malfunctioning.
Is the tap filter clean? If the
water is very calcareous, or if
work has recently been carried
out on the water piping, the tap
filter could be clogged with
particles and debris.
Is the rubber hose bent? The
tract of the rubber hose
bringing water to the washer-
dryer must be as straight as
possible. Make sure it is not
squashed or bent.
The programme
selector knob keeps
turning?
Wait a few minutes for the
drain pump to empty the tub,
switch Margherita off, select
one of the symbols stop/reset
, then switch it back on. If
the knob continues to turn, call
for assistance because it is
reporting an anomaly.
The washer-dryer
continuously loads
and unloads water.
Is the drain hose
positioned too low? It must
be installed at a height ranging
from 60 to 100 cm.
Is the hoses mouth
immersed in water?
Does the wall drainage
system have a breather
pipe? If the problem persists
even after these checks, close
the water tap, switch the
appliance off and call for
assistance.
If you live on an upper floor of
your building, there may be a
problem with your drain trap.
To solve this problem, a special
valve must be installed.
9
Simple: with the new Ariston technology, you need less than
half of it, to get good results on twice as much!
This is why you cannot see the water through the door:
because there is little, very little of it, to respect the
environment yet without renouncing maximum cleanliness.
And, on top of that, you are also saving electricity.
But where did all the water go?

Содержание

EJ ARGHER1TA Troubleshooting Before calling read the following Your washer diyer could fail to work In most cases the problems arising can be easily solvedwithout having to call for a technician Before calling for assistance always check these points The washer dryer to start fails Is the plug correctly inserted into the socket It could have been moved whilst cleaning diyer cannot work if the door is open or not shut properly Is the On Off button pressed If it is then a programmed start has been set Is the programmed start knob on those models concerned in the correct position But where did all the water go de with the new Ariston technology youneedless than ofit togetgoodresultsontwiceasmuch This is why you cannot see the water through the door because there is little very little of it to respect the environmentyetwithoutrenouncing maximum cleanliness And on top of that you ar e also saving electricity a Is there electricity in the house A circuit breaker could have gone off perhaps because too many appliances are on at the same time Orperhaps because of a general power failure in your entire area Is the washer dryer door closed properly For safety reasons the washer Is the water tap open For safety reasons if the washer dryer does not load water it cannot start a wash cycle The programme selector knob keeps turning Wait a few minutes for the drain pump to empty the tub switch Margherita off select one of the symbols stop reset then switch it back on If the knob continuesto turn call for assistance because it is reporting an anomaly The washer dryer fails to load water RIGHT WRONG Close the tap after every wash cycle Limit the use of the washer dryer s hydraulic system and eliminate leakage risks when no one is at home Always leave the appliance door ajar to avoid bad odours Clean the appliance s exteriors delicately To clean the exteriors and the rubber parts of the appliance always use a rag dipped in lukewarm water and soap Leave the washer dryer plugged in while cleaning Even during mainte nance the appliance should always be unplugged Use solvents and aggressive abrasives Never use solvents or abrasives to clean the external and rubber parts of the washer dryer Neglect the detergent dispenser It is removable and can easily be cleaned by leaving it under running water Go on holiday without thinking about her Before leaving always make sure that the washer dryer is unplugged and that the water tap is closed 9 Margherita Instructions for installation and use Is the tap correctly attached to the pipe Is there a water shortage There could be work in progress in your building or street Is there enough pressure The autoclave may be malfunctioning I Is the tap filter clean If the water is very calcareous or if workhas recently beencarried out on the water piping the tap filter could be clogged with particles and debris I Is the rubber hose bent The tract of the rubber hose bringing water to the washer dryer must be as straight as possible Make sure it is not squashed or bent The washer dryer continuously loads and unloads water Is the drain hose positioned too low It must be installed at a height ranging from 60 to 100 cm Is the hose s immersed in water Does the wall drainage system have a breather pipe If the problem persists even after these checks close the water tap switch the appliance off and call for assistance If you five on an upper floor of your building there may be a problem with your drain trap Ib solve thisproblem a special valve must be installed mouth

Скачать
Случайные обсуждения