Ariston AL 108 D [13/76] Technical characteristics

Ariston AL 108 D [13/76] Technical characteristics
Margherita - Iinstructions for installation and use
MM
ARGHERITA
Model
AL 108 D
Dimensions
width 59,5 cm
height 85 cm
depth 53,5 cm
Capacity
from 1 to 5,5 kg for the wash programme; from 1 to 4 kg for the drying
programme
Electrical
connections
voltage 220/230 Volt 50 Hz
maximum absorbed power 1850 W
Water
connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0,05 MPa (0,5 bar)
drum capacity 46 litre
Spinning speed
up to 1000 rpm
Control programs
in compliance
with IEC
regulation 456
wash: programme 3; temperature 60°C; carried out with 5 kg load.
drying: run with a load of 2.5 kg and knob C set to position .
This appliance conforms with the following E.E.C. directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications
- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and
subsequent modifications
The washer-dryer
does not drain or spin.
Does the selected
programme foresee water
draining? Some wash cycles
require enabling the draining
manually.
Is the Easy iron" function
-where provided - enabled?
This function require enabling
the draining manually.
Is the drain pump clogged?
To check it, close the tap,
unplug the washer-dryer and
follow the instructions on page
12, or call for technical
assistance.
Is the drain hose bent? The
tract of the drain hose must be
as straight as possible. Make
sure it is not squashed or bent.
Is the washer-dryers drain
duct clogged? Is there an
extension of the drain hose? If
so, is it positioned incorrectly,
blocking the water flow?
The washer-dryer
vibrates too much
during the spin cycle.
Has the internal floating
unit been correctly
unblocked during
installation? See the
following page on installation
procedures.
Has the washer-dryer been
levelled correctly? The
levelling of the appliance
should be checked
periodically. In time, the
machine could move
imperceptibly. Adjust the feet
and check them with a level.
Is the appliance closed in
between furniture and a
wall? If it is not a built-in
model, the washer-dryer needs
to oscillate a bit during the
spin cycle. A few cm of space
should therefore be left around
it.
The washer-dryer
leaks.
Is the metal ring of the inlet
hose properly attached?
Close the tap, unplug the
appliance and try tightening its
attachment without forcing it.
Is the detergent dispenser
obstructed? Try extracting it
and washing it under tap
water.
Is the drain hose well
attached? Close the tap,
unplug the appliance and try
tightening its attachment.
Too much foam.
Is the detergent appropriate
for machine washing? Check
whether its label reads the
definition for machine wash
or hand and machine wash,
or other similar indications.
Is the correct amount being
used? An excessive amount of
detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling in the
internal parts of the appliance.
The washer-dryer
does not dry.
Check whether:
the plug has been correctly
inserted into the socket; there
is electricity in your home; the
appliance door has been shut
properly; a delayed start (if
available) has not been selected;
programme knob A has been set
to position
(Stop/Reset); the
drying cycle knob C has been
set to position 0.
The washer-dryer
doesn't dry properly.
Check whether:
the end of the drain hose is
underwater; the drain pump is
obstructed; the advice given on
the maximum loads has been
taken; the water tap has been
turned on.
If, despite all checks, the washer-
dryer fails to function and the
problem persists, call your
nearest authorised Customer
Service Centre, providing the
following information:
- the type of malfunctioning
- the model type no. (Mod. ....)
- the serial number (S/N ....)
These indications can be found
on the data plate situated on the
back of the washer-dryer.
Technical characteristics
Always get
assistance from
authorised
technicians and
always insist on
original spare
parts.
10

Содержание

ARGHERITA I Is the drain hose bent The tract of the drain hose must be as straight as possible Make sure it is not squashed or bent I Is the washer dryer s drain duct clogged Is there an extension of the drain hose If so is it positioned incorrectly blocking the water flow The washer dryer does not drain or spin Ils the appliance closed in between furniture and a wall If it is not a built in model the washer diyer needs to oscillate a bit during the spin cycle A few cm of space should therefore be left around it Is the detergent appropriate for machine washing Check whether its label reads the definition formachine wash or hand and machine wash or other similar indications Does the selected programme foresee water draining Some wash cycles require enabling the draining manually Is the Easy iron function where provided enabled This function require enabling the draining manually Is the drain pump clogged To check it close the tap unplug the washer dryer and follow the instructions on page 12 or call for technical assistance The washer dryer vibrates too much during the spin cycle Has the internal floating unit been correctly unblocked during installation See the following page on installation procedures Has the washer dryer been levelled correctly The levelling of the appliance should be checked periodically In time the machine could move imperceptibly Adjust the feet and check them with a level Always get assistance from authorised technicians and always insist on original spare parts The washer dryer leaks Is the metal ring of the inlet hose properly attached Close the tap unplug the appliance and try tightening its attachment without forcing it Is the detergent dispenser obstructed Try extracting it and washing it under tap water Is the drain hose well attached Close the tap unplug the appliance and try tightening its attachment Model AL 108 D Dimensions width 59 5 cm height 85 cm depth 53 5 cm Capacity from 1 to 5 5 kg for the wash programme from 1 to 4 kg for the diying programme Electrical conn ections voltage 220 230 Volt 50 Hz maximum absorbed power 1850 W Water conn ections maximum pressure 1 MPa 10 bar minimum pressure 0 05 MPa 0 5 bar drum capacity 46 litre Spinning speed up to 1000 rpm Control programs in compliance with IEC regulation 456 wash programme 3 temperature 60 C carried out with 5 kg load drying run with a load of 2 5 kg and knob C set to position J Is the correct amount being used An excessive amount of detergent besides producing too much foam does not guarantee a more effective wash and causesscalinginthe internal parts of the appliance The washer dryer does not dry Check whether the plug has been correctly inserted into the socket there is electricity in your home the appliance door has been shut properly a delayed start if available has not beenselected programme knob Ahasbeenset to position St op Reset the drying cycle knob C has been set to position 0 The washer dryer doesn t dry properly Technical characteristics Æ V Too much foam Check whether the end of the drain hose is underwater the drain pump is obstructed the advice given on the maximum loads has been taken the water tap has been turned on If despite all checks the washer dryer fails to function and the problem persists call your nearest authorised Customer Sendee Centre providing the following information the type of malfunctioning the model type no Mod the serial number S N These indications can be found on the data plate situated on the back of the washer diyer This appliance conforms with the following E E C directives 73 23 EEC of 19 02 73 Low Voltage and subsequent modifications 89 336 EEC of 03 05 89 Electromagnetic Compatibility and subsequent modifications Margherita instructions for installation and use 10

Скачать
Случайные обсуждения