MEAN WELL ELG-75-C500A [2/12] Elg 75
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

MEAN WELL ELG-75-C500A [2/12] Elg 75

MEAN WELL ELG-75-C700 [2/12] Elg 75
60~75W Constant Current Mode LED Driver
ELG-75-C series
SPECIFICATION
MODEL
RATED CURRENT
RATED POWER
Note.5
OUTPUT
CURRENT ADJ. RANGE
SET UP TIME
Note.4
VOLTAGE RANGE Note.3
FREQUENCY RANGE
POWER FACTOR
(Typ.)
EFFICIENCY (Typ.)
AC CURRENT(Typ.)
INPUT
INRUSH CURRENT
(Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS
EMC IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVER TEMPERATURE
OVER VOLTAGE
500ms/115VAC,230VAC
(Please refer to "STATIC CHARACTERISTIC" )
section
47 ~ 63Hz
PF 0.97/115VAC, PF 0.95/230VAC, PF 0.92/277VAC@full load≧≧≧
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
0.7A / 115VAC 0.45A / 230VAC 0.38A/277VAC
<0.75mA / 277VAC
Compliance to EN55015,EN61000-3-2 Class C (@load 50%) ; EN61000-3-3;≧ GB17743, GB17625.1;
EAC TP TC 020; KC KN15 KN61547,
20 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.03%/ (0 ~ 60 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
180 6* 3*35.5 mm (L*W*H)
ENVIRONMENT
EMC EMISSION
SAFETY &
EMC
PROTECTION
225 ~ 260V
Shut down o/p voltage, re-power on to recover
Shut down o/p voltage, re-power on to recover
SHORT CIRCUIT
91%
107 ~ 214V
ELG-75-C350
ELG-75-C700
Hiccup mode, recovers automatically after fault condition is removed
175 ~ 350mA
350 ~ 700mA
350mA
74.9W
I/P-O/P:3.75KVAC I/P-FG:2.0KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
90%
115 ~ 140V
53 ~ 107V
700mA
74.9W
ELG-75-C1050
525 ~ 1050mA
90%
80 ~ 100V
35 ~ 71V
1050mA
74.55W
CURRENT TOLERANCE
±5.0%
160 ~ 190V
91%
75 ~ 150V
ELG-75-C500
250 ~ 500mA
500mA
75W
ELG-75-C1400
700 ~ 1400mA
90%
64 ~ 79V
27 ~ 54V
1400mA
75.6W
CONSTANT CURRENT REGION
Note.2
THD< 20%(@load 50%/115VC,230VAC; @load 75%/277VAC)≧≧
(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)
TOTAL HARMONIC DISTORTION
OPEN CIRCUIT VOLTAGE
(max.)
224V
114V
78V
158V
61V
Adjustable for A/AB-Type only (via built-in potentiometer)
COLD START 50A(twidth= s measured at 50% Ipeak)/230VAC350 Per NEMA 410μ;
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
5 units (circuit breaker of type B) / 8 units (circuit breaker of type C) at 230VAC
Tcase=-40 ~ +85 (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)℃
MAX. CASE TEMP.
Tcase=+85℃
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level(surge immunity:Line-Earth:6KV,Line-Line:4KV);
EAC TP TC 020; KC KN15 KN61547,
1. All parameters NOT specially mentioned are measured at 230VAC input, rated and 25 of ambient temperature.current ℃
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details
4. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.
5. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 80 or less.℃
7. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com
8.The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃
9. For any application note and IP water proof function installation caution, please refer our user manual before using.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
0.8Kg;16pcs/13.4Kg/0.67CUFT
CURRENT RIPPLE 5.0% max. @rated current
100 ~ 305VAC 142 ~ 431VDC
No load power consumption <0.5W for Blank / A / Dx / D2-Type
NO LOAD / STANDBY
POWER CONSUMPTION
Standby power consumption <0.5W for B / AB / DA -Type
UL8750 independent, EN62384;(type”HL”), CSA C22.2 No. 250.13-12;EN/AS/NZS 61347-1, EN/AS/NZS 61347-2-13
;IP65 or IP67; ;GB19510.1, GB19510.14EAC TP TC 004;BIS IS15885(for 700A/1050A only)
approvedKC61347 1 KC61347 2 13-, --
1171.4K hrs min. Telcordia SR-332 (Bellcore) 305Khrs min. MIL-HDBK-217F (25 )℃
DALI STANDARDS Compliance to IEC62386-101, 102, 207 for DA-Type only
60W
59.85W
59.85W
59.5W
60.2W
200VAC ~ 305VAC
100VAC ~ 180VAC
File Name:ELG-75-C-SPEC 2018-09-30

Содержание

Похожие устройства

Скачать