Electrolux EWF 1427 [5/96] Installation

Electrolux EWF 1427 [5/96] Installation
ENGLISH
Installation
5
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the two rear
bottom screws. Slide out the two plastic pins.
2. Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by
placing one of the corner packing pieces
between the machine and the floor.
3. Remove the polystyrene block from the bottom
of the machine and release the two plastic bags.
4. Very carefully slide out the left polythene bag,
removing it towards the right and then
downwards.
5. Very carefully slide out the right polythene bag,
removing it towards the left and then upwards.
6. Set the machine upright and remove the
remaining rear screw. Slide out the relevant pin.
P1127
P1126
P1124
2
3
1
P0001
P1129
7. Plug all the holes with the plugs which you will
find in the envelope containing the instruction
booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
Water inlet
Connect the water inlet hose to a tap with a 3/4"
thread.
Do not use already employed hoses for water
connection.
Important!
Before connecting up the machine to new pipework
or to pipework that has not been used for some
time, run off a reasonable amount of water to flush
out any debris that may have collected in the pipes.
P1088
P1051
P0002
P1128
132982830 GB.qxd 02/03/2006 8.36 Pagina 5

Содержание

Unpacking 7 Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet All transit bolts and packing must be removed before using the appliance You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again 1 Using a spanner unscrew and remove the two rear bottom screws Slide out the two plastic pins PI 128 j Jj P00Q2 ____________ Positioning 5 Install the machine on a flat hard floor Make sure that air circulation around the machine is not impeded by carpets rugs etc Check that the machine does not touch the wall or other kitchen units Carefully level by screwing the adjustable feet in or out Never place cardboard wood or similar materials under the machine to compensate for any unevenness in the floor j _____________________ P 11______________________ I_________________ 2 Lay the machine on its back taking care not to squash the hoses This can be avoided by placing one of the corner packing pieces between the machine and the floor 3 Remove the polystyrene block from the bottom of the machine and release the two plastic bags ЖкА who PII24 Water inlet j Connect the water inlet hose to a tap with a 3 4 thread 4 Very carefully slide out the left polythene bag removing it towards the right and then downwards Do not use already employed hoses for water connection 5 Very carefully slide out the right polythene bag removing it towards the left and then upwards L _ZZJ Important Before connecting up the machine to new pipework or to pipework that has not been used for some time run off a reasonable amount of water to flush out any debris that may have collected in the pipes 6 Set the machine upright and remove the remaining rear screw Slide out the relevant pin 5 ENGLISH Installation

Скачать