Planet WL-U356M Инструкция по эксплуатации онлайн [27/34] 65742

The difference between WPA and WPA2 is that WPA2 provides

data encryption via the AES. In contrast, WPA uses Temporal Key

Integrity Protocol (TKIP).

Encryption Method

Security Off – Disable the encryption mode.

WEP – Enable the WEP Data Encryption. When the item is

selected, you have to continue setting the WEP Encryption keys.

TKIP – TKIP (Temporal Key Integrity Protocol) changes the

temporal key every 10,000 packets (a packet is a kind of message

transmitted over a network.) This insures much greater security

than the standard WEP security.

AES – AES has been developed to ensure the highest degree of

security and authenticity for digital information and it is the most

advanced solution defined by IEEE 802.11i for the security in the

wireless network.

Note: All devices in the network should use the same encryption

method to ensure the communication.

802.1x Authentication

Protocol

The EAP authentication protocols this device has supported are

included as follows. This setting has to be consistent with the

wireless APs or Routers that the card intends to connect.

EAP/TLS (User Certificate) –EAP/TLS is the most secure of the

EAP protocols but not easy to use. It requires that digital

certificates be exchanged in the authentication phase. The server

presents a certificate to the client. After validating the server’s

certificate, the client presents a client certificate to the server for

validation.

Passphrase

The WPA-PSK / WPA2-PSK can be from 8 to 64 characters and

can be letters or numbers. This same key must be used on all of

the wireless stations in the network.

WEP Key(Key1 ~ Key4)

The WEP keys are used to encrypt data transmitted in the wireless

network. There are two types of key length: 40-Bit and 104-Bit.

Fill the text box by following the rules below.

40-Bit – Input 10-digit Hex values (in the “A-F”, “a-f” and “0-9”

range) or 5-digit ASCII characters (including “a-z” and “0-9”) as the

encryption keys. For example: “0123456aef“ or “test1”.

104-Bit – Input 26-digit Hex values (in the “A-F”, “a-f” and “0-9”

range) or 13-digit ASCII characters (including “a-z” and “0-9”) as

the encryption keys. For example:

“01234567890123456789abcdef“ or “administrator”.