Planet MAP-2105 Инструкция по эксплуатации онлайн [59/66] 65757

Pass Phrase

The middle panel is to configure the Access control of the SNMP. Click the Set Access Config

button to load the settings.

The parameters at this section

From WAN Interface

Check the checkbox to allowed the access from WAN device to SNMP

From VPN Interface

Check the checkbox to allowed the access from VPN device to SNMP

From Network Interface

Check the checkbox to allowed network to access the SNMP

Subnet

The Subnet IP Address of the allowed network. This field is disabled if From Network

Interface is disabled

Netmask

The Netmask, corresponding to the Subnet IP Address, of the allowed network

The bottom panel allowed user to configure details regarding the SNMP Trap. Click on the Set

Trap Configurations button to enable the settings.

The parameters at this section

Enable SNMP Trap

Check this option to enable the use of SNMP Traps

SNMP Trap Version

Specifies the SNMP version used for the SNMP Trap. Three options are available: SNMP

v1 or v2c, SNMP v3, and both

Destination IP Address

Specifies the destination IP Address to send the trap message to. Fill in the IP Address of

the Trap Viewer will enable the Trap Viewer to capture the trap release by this node