Planet WAP-6000 [16/33] System properties

- -

Current IP Settings

· This section shows current IP address setting including IP address, Subnet Mask, Default

Gateway and DHCP status.

Current Wireless Settings

· This area shows current wireless setting including operation mode, wireless mode, SSID,

channel and security setting.

4.1.2 System Properties

Device Name You may assign any name to the WAP-6000. Memorable, Unique

names are helpful especially if you are employing multiple access

points on the same network. The device name needs to be less than

32 characters. After verify the name you input and click “Apply” to

save the setting.

Country / Region Here you can set the WAP-6000 to follow different country and

region regulations.

Operation Mode The default operation mode is Access Point; this mode connects

your wireless clients to a wired network. In most cases, no change is

necessary. You can switch operation mode to Wireless Client or

Repeater mode depends on your application. Wireless Client mode

can allow AP act as a client within its range. Your Ethernet devices

behind the AP client can connect to a remote AP. Repeater is able to

retransmit the signal of a remote AP. Choose repeater mode if you

want to extend the range of your original AP.