Vitek VT-1190 [3/32] English
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Vitek VT-1190 [3/32] English

Vitek VT-1190 [3/32] English
3
E N G L I S H
THERMOPOT VT-1190
An electric thermopot is intended for boiling water
and maintaining the required temperature of water.
DESCRIPTION
1. Minimal water level mark «MIN»
2. Water level scale
3. Water dispense on button
4. Spout for pouring water
5. Control panel
6. Lid opening button
7. Steam release openings
8. Removable upper lid
9. Lid lock
10. Carrying handle
11. Body
12. Power cord connector
13. Rotary base
14. Sealing gasket
15. Maximal water level mark «FULL»
16. Power cord
Control panel
17. Boiling mode indicator “BOILING”
18. Keep warm mode indicators
«45°С-55°С-65°С-85°С-95°С»
19. «ROOM TEMP» indicator
20. Unlocked water dispensing indicator “ ”
21. «UN/LOCK» button
22. Water dispense on button «DISPENSE»
23. Water temperature selection button
«TEMP.SET/KEEP WARM»
24. Reboil button «REBOIL»
ATTENTION!
For additional protection it is reasonable to install
a residual current device (RCD) with nominal
operation current not exceeding 30 mA, to install
RCD, contact a specialist.
SAFETY MEASURES
• Before using the electric thermopot, read this
instruction manual carefully.
• Make sure that the operating voltage of the
unit corresponds to the voltage of your mains.
• The power cord is equipped with a “euro
plug”; plug it into the socket with reliable
grounding contact.
• To avoid fire, do not use adapters for plug-
ging the unit in.
• Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
• When unplugging the unit, always pull the plug
but not the cord.
• Never leave the operating unit unattended.
• Do not switch the thermopot on if it is empty.
• Do not drop or tilt the unit.
• Use the thermopot only for water boiling;
it is prohibited to heat or boil other liquids
in it.
• Ensure that water level in the thermopot is
not below the «MIN» mark and not above the
«MAX» mark.
• Do not fill the thermopot with water directly
from the faucet; to fill the thermopot use a
suitable bowl.
• Place the thermopot on a flat dry and stable
surface; do not place the thermopot on the
edge of the table.
• Do not place the thermopot next to the walls
or close to the kitchen furniture.
• Place the thermopot keeping at least 20 cm
gap between the thermopot body and the
wall and at least 30 cm gap above the ther-
mopot.
• Do not use the unit near heat sources or open
fire.
• Do not let the power cord hang from the edge
of the table and make sure it does not touch
hot or sharp edges of furniture.
• Do not open the lid and do not pour water out
during boiling.
• Do not rotate the unit during water pouring.
• Do not apply excessive effort when closing
the lid. When using the thermopot, make sure
that the lid is closed tightly.
• Keep your hands away and do not bend over
the steam release openings, it may cause
burns. Do not block the steam release open-
ing with any objects.
• Do not touch hot surfaces of the thermopot.
• Be careful while carrying the thermopot filled
with boiling water.
• Do not carry the thermopot holding it by the lid
opening button.
• Be careful when pouring out hot water.
• Remove the lid before draining the remaining
hot water from the thermopot flask.
• To avoid risk of electric shock, do not immerse
the thermopot, the power cord and the power
plug of the unit into water or other liquids.
• Unplug the unit, if you are not using it or
before cleaning.
• Do not wash the thermopot in a dishwashing
machine.
IM VT-1190.indd 3 11.04.2019 15:03:05

Содержание

Похожие устройства

Скачать