Icom IC-F43GT [23/47] Biis operation

BIIS OPERATION

Direct code entry

q While in the standby condition, push [P3] (TX Code Enter)

to enter the TX code edit mode.

• Editable code digit blinks.

w Push [P3] (TX Code Enter) to select the desired digit to be

edited.

• Editable digit differs according to the setting.

e Set the desired digit using [CH Up]/[CH Down]/[TX Code

CH Up]/[TX Code CH Down] or 10-keypad.*

*Depending on version

r Push [P3] (TX Code Enter) to set the digit, then the

editable digit will move to the right automatically.

• When the 10-keypad is used to set, the editable digit will move to

the right automatically without pushing [P3] (TX Code Enter).

t Repeat e and r to input all allowable digits.

y Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the trans-

ceiver repeats the call 3 times (default) automatically,

and

“”is displayed during each call. However, an

error beep sounds and

“”is displayed when no

answer back is received after the calls.

u Push [PTT] to transmit; release to receive.

i Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’

signal.

For your information

When the “UpDate” setting for the call code is enabled, the

set code is overwritten into the call code memory.

IC-F33_43GT_GS-1.qxd 04.8.31 8:46 AM Page 19 (1,1)