Home
Главная
Philips
Парогенератор
GC8320
Инструкция по эксплуатации Страница: 16

Philips GC8320 [16/190] English

Problem Cause Solution

Steam escapes from

under the Calc-

Clean rinsing cap

when the appliance

heats up.

You have not tightened the Calc-clean

rinsing cap properly.

Switch off the appliance, tighten

the Calc-Clean rinsing cap and

switch on the appliance again. If

steam continues to escape when

the appliance is heating up, switch

off the appliance and contact a

service centre authorised by Philips.

The iron does not

produce enough

steam/the amount

of steam decreases

and increases during

steam ironing.

When the appliance pumps water into

the steam generator, the steam amount

sometimes decreases. This is probably

when you think that the iron does not

produce enough steam. However, this is

a normal phenomenon and the steam

output normalises within a few seconds.

To optimise the steam output,

release the steam lock when you do

not need steam and when you put

down the iron.

Wet spots appear

on the fabric during

ironing.

The wet spots that appear on the fabric

after you have steam ironed for some

time may be caused by steam that has

condensed onto the ironing board. Iron

the wet spots without steam for some

time to dry them. If the underside of the

ironing board is wet, wipe it with a piece

of dry cloth.

To prevent steam from condensing

onto the ironing board, use an

ironing board with a wire mesh top.

Water droplets

come out of the

soleplate when I use

the shot-of-steam

function.

Steam may have condensed in the hose,

the temperature may have been set below

3 or the appliance may not be ready

for steam ironing.

Make sure the temperature is set

to 3 or higher. Steam iron for

a few seconds before you use the

shot-of-steam function.

ENGLISH16

Содержание

Похожие устройства

16 ENGLISH Problem Cause Solution Steam escapes from under the CalcClean rinsing cap when the appliance heats up You have not tightened the Calc clean rinsing cap properly Switch off the appliance tighten the Calc Clean rinsing cap and switch on the appliance again If steam continues to escape when the appliance is heating up switch off the appliance and contact a service centre authorised by Philips The iron does not produce enough steam the amount of steam decreases and increases during steam ironing When the appliance pumps water into the steam generator the steam amount sometimes decreases This is probably when you think that the iron does not produce enough steam However this is a normal phenomenon and the steam output normalises within a few seconds To optimise the steam output release the steam lock when you do not need steam and when you put down the iron Wet spots appear on the fabric during ironing The wet spots that appear on the fabric after you have steam ironed for some time may be caused by steam that has condensed onto the ironing board Iron the wet spots without steam for some time to dry them If the underside of the ironing board is wet wipe it with a piece of dry cloth To prevent steam from condensing onto the ironing board use an ironing board with a wire mesh top Water droplets come out of the soleplate when I use the shot of steam function Steam may have condensed in the hose the temperature may have been set below or the appliance may not be ready for steam ironing Make sure the temperature is set to or higher Steam iron for a few seconds before you use the shot of steam function

Скачать