Daikin FLY40GAV1NB [8/19] Preparation before operation
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Daikin FLY40GAV1NB [8/19] Preparation before operation

Daikin FLY40GAV1NB [8/19] Preparation before operation

Содержание

Похожие устройства

Preparation Before Operation Remote controller Setting the batteries Operating the remote controller To use the remote controller aim the transmitter at the indoor unit If there is anything to block signals between the unit and the remote controller such as a curtain the unit will not operate Do not drop the remote controller Do not get it wet The maximum distance for communication is about 7 m To fix the remote controller holder on the wall Choose a place from where the signals reach the unit I Press S with a finger and slide the front cover to take it off 2 Fix the holder to a wall a pillar etc with the screws supplied with the holder 2 Set dry batteries AAA 3 Place the remote control in the remote control holder 3 Set the front cover as before This will cause the figures on the display to blink Set the clock at this point The address switch is used when two indoor units are to be Installed in a single room If there is only one indoor unit in the room it must be set to 1 To install two units in a single room consult the shop where you bought the air conditioner x ATTENTION About batteries When replacing the batteries use batteries of the same type and replace the two old batteries together When the system is not used for a long time take the batteries out When the operation display screen of the remote controller is hard to see and the reception become hard replace the batteries with new AAA batteries The attached batteries are provided for the initial use of the system The usable period of the batteries may be short depending on the manufactured date of the air conditioner x ATTENTION About the remote controller Never expose the remote controller to direct sunlight Dust on the signal transmitter or receiver will reduce the sensitivity Wipe off dust with soft cloth Signal communication may be disabled if an electronic starter type fluorescent lamp such as inverter type lamps is in the room Consult the shop if that is the case If the remote control signals happen to operate another appliance move that appliance to somewhere else or consult the shop 7

Скачать